Mercury Cougar -70 351 Cleveland reving
When all was OK after restoration 2006. A mild setup with Crane HMV-260-2
Edelbrock 2V, Holley 600 VAC and headers.
Running beautiful until it dropped a valve. The original Ford valve ....
This year 2010 I will do another restoration with allmost the same setup.
351C Capri Drag Car (Rompa Stompa Racing)
Mk2 Capri Pro Street Drag Car...Runs 9.85 @ 136.5mph Normally Aspirated
351C standard 3.5 stroke,11-1 comp can run on pump gas...will oneday
introduce it to the Dyno alittle more in it yet.
1970 Cougar Street Driven 10 Second Drag Car
This is HotRodMercs/ Tony Barnes 1970 Cougar. It is a real street car and
runs mid to low 10s. Big Block 460, but this thing weighs 3600 pounds and
runs on 10 inch DOT drag tires. This was last year at Mason Dixon Dragway.
F100 408c Cleveland drag race 1/8 mile
This pass was leaving off of the foot brake at about 3000 rpms. Converter
flashes to 5000, so it hits pretty hard. Ran a 1.903 60', 8.029 @ 89.85.
1.5 turns preload on both sides for Caltracs, 7/7 on Rancho 9000's, 14 psi
in the 325/50r15 M/T ET Streets. Seemed to kinda initially spin and then
hook and bounce.
1970 Cougar 351c Dyno Run Dyno run with the
Cougar. It made 270hp at the wheels at 5400 rpm. Not too sure how
accurate that figure is as I run 104 Mph in the 1/4. Notice the policeman
New 417ci CHI engine (351 cleveland drag)
This is my new 417ci CHI cleveland based ford. On 98 octane pump fuel with
out of the box heads,manifold and 1050 dominator carb it went 682hp @7k and
Nothing exotic or trick other than a solid roller camshaft. This was the
virgin startup and never got a vid of a pull sorry. Going into a 3550lb XD