Supercharged home made Straight Eight by Desperate Dan Vid 2
Built in a shed, it fired up first go. I was hoping it would sound real
lumpy like a drag engine, but it runs too smooth, and it's too quiet even
with unsilenced 9" pipes! The timing was a pain to sort out the Rover
distributor runs backwards, I had to take the heads off to work out the
firing order!!! See the shed it was built in on Vid 1.
Added May 2012: OK, my nails are dirty, maybe because I'm an engineer &
build stuff? Maybe your nails are clean because you can't build eff-all &
just sit behind your computer? C'mon folk, get a life.
Ford Capri RS 2600 Cosworth V6 dyno crash failure
See more at https://www.facebook.com/CapriRS2600
Partial throttle runs for fuel mapping. Dyno was set to sweep
1000-7000rpm in 18 seconds. Limiter at 6450rpm. Crash at 5400rpm most
likely due bad conrod bearing.
Highlights of season 2013:
Season 2014 races:
Sherman Tank Engine
This is an 1100 Cu in. all aluminum Ford 4 cam, 32 valve v-8 that is used
in a WWII Sherman Tank. This engine style is also used in the M26
Ford Cosworth v6 2.9ltr 24v BOA
Firing up a Ford Cosworth v6 2.9ltr 24v BOA engine taken from a ford
scorpio. the engine is running stock ecu and a custom made wiring to be
able to fit on a lotus caterham replica
MK2 Escort 4 door with N/A Cosworth engine
first vid of my newly built 4 door, with a 230hp Vulcan Engineering
Naturally aspirated Cosworth engine. Its a 2.1, on HT Racing Slide Throttle
bodies, Emerald ECU. Car has 100% brand new running gear, from suspension,
to diff, brakes etc. Going to use it HARD for drifting and track days. Iv'e
gone for the rat look, so if i crash it i wont cry as much. :-) MASSIVE
Thanks to Neil @ NTS auto for all his help with the build.
very powerfull sierra cosworth, 775 hp and 950nm in engine
its possible to get more. to rich .hi
i live in Norway, the cost for this built is about 300000 norwegian kroner.
It is expencive to built this car. Here is a link about the car. its in
Now i change the engine. 2jz gte is the new engine. Spec: cp piston 10:1
comp. bc cams 280 duration 11,43 lift. ferrea stanless 1mm oversize valves,
bc titan retainers and springs. bc sportsman rods 200hp each. 6 total 1200
hp. clevite bearings, gtk 850 turbonetics, 1680 bosch injectors, e85 fuel. nira
3 ecu. vw coil on plugg, titan tensioner , tilton flywheel and 3 plated
clutch. Full ported head. titan billet main cap, arp studs all over. goal
is 870 hp at the wheel. Next year new turbo, 1200 hp turbo.