Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

Subaru playing in mud

Buddy's Subaru Loyale playing in the mud. Yes its loud.


 


More Videos...


Subaru off-road.wmv
Video with sound: http://www.videogaga.lt/video?id=oxmciayeekilzkkfi





Subaru Off-Road
Subaru Off-Roading





testing the limits of my Subaru L series, nearly roll it!
4x4 Dual Range Subaru, Kumho 14" KL71 27x8.50, 2" lift, King Springs





Subaru Winter start up -44c
Typical winter start up at -44c in Yellowknife, NT Canada. Block heater turned on for 4 hrs.





Stock Subaru Loyale wheeling
crappy video of me wheeling my stock Subaru Loyale at Rock Candy near Olympia





sawdy escort mudding
escort mud car





Subaru Hillclimb... well, a little one...
Climbing a small hill with the loyale!





How to Replace Axle Subaru
Important Update!!! "It specifically says that unless you are fitting new wheel bearings to the car that you should never break loose the axel nut while the weight of the car is on the wheel and tire. Damage to the wheel bearing is likely. The procedure they recommend is to jack the car up remove the wheel then have someone hold the brake firmly while you break the nut loose from the axel." ~Special thanks to 1audionote for the tip~ In this video I show how to remove the driver, and passenger side axles on a Subaru. This covers a large majority of the Subaru's out there including the Legacy Outback, and more. Click here to show thanks, and help support Fixbook: http://www.hondahowto.com/p/blog-page_25.html Click this link to watch the full laptop video: http://www.youtube.com/watch?v=7z6z9Fz-PNM Click this link to watch "How Could an All Powerful God Let People Suffer?": https://www.youtube.com/watch?v=ejT3VeVhJfM Click this link to watch the random video pick of the day: Click this link to Subscribe: http://www.youtube.com/subscription_center?add_user=Hondahowto1&annotation_ id=annotation_59253&feature=iv&src_vid=QSNjtNYuD18 I, Jordan, assume no liability for anything you choose to do to your car, before, or after watching one of my videos, including this one. All DIY repairs, or modifications, you perform to your car are made at your own risk. Sometimes, even if you've done everything the right way, you can destroy, or damage, a piece, or part. You must understand this; part of doing a repair, and/or modification is messing up sometimes. Also, if for some reason, I do give incorrect instructions, and something breaks because you followed my instructions, I still will not reimburse, or pay, in any way, for whatever cost that may be incurred. Fixbook DIY Car Repair





How To Replace CV Boots - EricTheCarGuy
How To Replace CV Boots - EricTheCarGuy http://www.ericthecarguy.com/ This one is a request from more than one person so I'm happy to bring it to you. As I said in the video I personally don't see much point of replacing just the CV boots anymore as it just makes more sense to replace the axle, that's just how I feel however. If you do want to replace the boots I hope this video will help. --- Click below and Stay Dirty Visit me at EricTheCarGuy.com http://ericthecarguy.com/ Visit EricTheCarGuy Forum http://www.ericthecarguy.com/forum/default.aspx Visit my Facebook Page: http://www.facebook.com/EricTheCarGuy --- ETCG Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.





Rock crawling with a stock subaru!
Playing around in a washout with a subaru loyale!





How To Replace a Front Wheel Drive Axle - EricTheCarGuy
If you start to notice your FWD vehicle clicking when you make a tight turn, you might have an issue with the outer CV joint. If you make a right turn, it's usually the left side that's bad and vice versa. Most axles are easy to replace and the one depicted in this video is fairly typical of what you run into. The main differences come in with how the lower ball joint is attached. I think this part will give you the most trouble. I often get asked about what to torque the axle nut to. To be hones, I don't know. I've only ever run them down with my impact. I've never had an issue doing it that way and I don't think you would either. Just be sure to stake the nut or install the cotter pin and retaining clip if it has one. If you'd like more information on how to deal with suspension noises, check out this article I wrote on the topic. http://www.ericthecarguy.com/faq/diagnosing-noises-in-your-car Video on CV boot replacement: http://www.youtube.com/watch?v=-S-ofMoWsr0 The best place for answers to your automotive questions: http://www.ericthecarguy.com Facebook: https://www.facebook.com/EricTheCarGuy?fref=ts Twitter: https://twitter.com/EricTheCarGuy Google+: https://plus.google.com/100195180196698058780/posts Information on Premium Membership: https://www.ericthecarguy.com/premium-content-streaming-etcg-content Stay Dirty ETCG Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.





Oops, Axle and Ball Joint Replacement - EricTheCarGuy
Oops, Axle and Ball Joint Replacement Sorry I missed you last week, I had this video half done and didn't get a chance to finish. Well we have our 1990 Accord again, I'm getting some mileage out of this one but I don't mind cause there are still quite a few of these on the road and a few of you have claimed ownership to one of these 4th generation Accords, so enjoy. A couple of things to note, I could do a video on taking out the wishbone bolt alone, I've run into a few problems here such as a rusted bolt that won't come out of it's bushing as one example, perhaps future videos will show how to overcome this problem. I thought this one went together well despite the fact that you might be getting sick of Honda Accords, I still have more from other makes that I haven't edited or posted yet. I have more to this video as well that may show up in DVD form at one point, YouTube only gives me 10min to work with but I think that is enough to get you started and not lose interest. Perhaps you could help by submitting questions in the form of text responses or what I would really like is a video response to something I've put out there, that would be great. Visit me at EricTheCarGuy.com http://ericthecarguy.com/ Visit EricTheCarGuy Forum http://www.ericthecarguy.com/forum/default.aspx Visit my Facebook Page: http://www.facebook.com/EricTheCarGuy Stay dirty ETCG Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.





2.5 inch Cherrybomb - Ned
This is the Custom Exhaust on my car. 1986 Subaru GL Sedan. EA82 1.8L Carburetor Engine. Cherrybomb is a 2.5 inch. Sounds pretty awesome! Ned and I will be at West Coast Subaru Show 13 this year! I dont wanna hear any "hater" comments, I dont care if you dont like my car or not, I love my car, he goes from Point A - Point B and does it safely, and fast ;)





drunk mudding
watch close and you can see the back window pop...





Subaru Loyale Straight Pipe
The other day the muffler was busted up on a rock, so I cut it off and replaced it with pipe and a turndown. Sounds nice, and there is more high end torque.




Which car is faster? Which Car is Faster?





Similar 1/4 mile timeslips to browse:

1997 Fiat Punto GT: 11.593 @ 121.000
Prodromos, Engine: 1600, Turbos: Garrett 2871 Tires: 24X8


1995 Fiat Punto gt: 11.983 @ 117.730
Quadrifoglio verde, Engine: 1400 ccm 85.4 c.i., Turbos: K-04 hybrid Tires: M-H racemaster


1994 Fiat Punto gt: 12.274 @ 117.740
Csak Zsolt RSP, Engine: 1.4 8v, Turbos: garrett T3/T4 Tires: matador 200/510 R13


2010 Tesla Roadster : 12.643 @ 102.890
Scotty,


2009 Tesla Roadster : 12.710 @ 105.310
NA, Engine: Electric 248HP,


1995 Fiat Punto GT Turbo: 13.229 @ 110.500
TurboCrime, Engine: 1.6 liter, Turbos: Garret T04E Tires: Marangoni ROAD tyres


2008 Tesla Roadster : 13.310 @ 104.230
NA,


2010 Fiat Punto abarth: 13.513 @ 170.690
andrew kalianos, Engine: stock, Turbos: td04 Tires: toyo r1r


1995 Fiat Punto GT: 13.750 @ 105.000
Rafi, Turbos: KKK K04 with T2 turbine Tires: Yokohama A005


1999 Saturn SL SL2T: 13.835 @ 107.680
Bill Allen, Engine: 1.9 LKO, Turbos: T3T04E Tires: Kuhmo 195/65 r15's


2010 Fiat Punto abarth: 14.000 @ 92.000
andrew kalianos, Engine: stock, Supercharger: stock Turbos: stock


1995 Fiat Punto GT: 14.227 @ 101.000
ThisisMartin, Engine: 1581, Turbos: Garrett TB2209 Tires: Slick Markgum


2008 Tesla Roadster : 14.647 @ 101.090
Jorg Brown, Engine: 375 volts,


1992 Saturn SL : 15.251 @ 79.780
Neil Gierman, Engine: 1.9L 4cyl SOHC, Tires: BF Goodrich Comp T/A Drag Radials (Front)


1996 Saturn SL : 16.730 @ 82.590
randy johnson, Engine: 1.9L SOHC, Supercharger: none Turbos: none Tires: 185/65/14 $50 el cheapo all season


 


©2014 DragTimes - Disclaimer