Why Killing SCION Was The Right Decision!
For this video, go discuss the possibilities of Scion and why it was eventually the right decision to get rid of-or just rebrand. Thanks for watching! Subscribe to my channel!: http://bit.ly/1FLCPRT Social stuff, Tshirts, and more below! My Social Stuff! Instagram/Twitter-Thatdudeinblue Like the Facebook!-https://www.facebook.com/thatdudeinblue Decals and Stickers!- http://spinnywhoosh.com/thatdudeinblue/?wpam_id=3 T-Shirts!-http://thatdudeinblue.spreadshirt.com Twitch!-http://www.twitch.tv/thatdudeinblue/profile Get some delicious JerkyXP powers here! COUPON CODE- Thatdudeinblue https://jerkyxp.com/JerkyTeamMember/16/ Outro Song- Lana Del Rey - Ultraviolence (Matstubs Remix)
2011 Scion xB K&N Performance Intake (INSTALL VIDEO)
SHF has teamed up with http://autoshepherd.com to give the Hermanation a FREE Christmas present this year! Anyone who "LIKES" the Autoshepherd facebook page from now until December 31st will be entered to win a FREE intake for their car! So be sure to like them Nation! Merry Christmas! http://www.facebook.com/ShopAutoShepherd Tools Needed 1. Ratchet 2. Deep Socket Extension 3. 8mm, 10mm, & 14mm sockets 4. 14mm Wrench 5. Screwdriver (Phillips) 6. Allen Wrench 7. Razor (0:03)- Introduction (1:33)- Let's prep for the install! (1:42)- "Eibach Sway Bar Install" 2010 2SS Camaro (2:04)- Tools Needed (3:11)- Disconnect Negative Battery Terminal & Remove Engine Cover (3:57)- Disconnect Mass Air Sensor, Un-Hook EVAP Solenoid Valve from Stock Intake Tube, Remove Upper Air Box & Remove Mass Air Sensor and then Install it on K&N Intake. (5:22)- Remove Lower Air Box, Remove Stock EVAP Mounting Bracket, Disconnect Crank Case Vent Hose & Completely Remove Stock Intake Tube (8:25)- Remove Fuel Rail Mounting Bolt & Install Tube Mounting Bracket, Install Silicone Step Hose on Throttle Body (Don't forget to put on your hose clamps!) (10:18)- Re-Evaluating the Directions with Tony (10:24)- Tony's Big Moment! (10:56)- Install Upper Hose Clamp on Silicone Step Hose (11:11)- Install EVAP Bracket (11:48)- Quick Altercation to Directions To Make Install 100% Easier (11:52)- Install K&N Intake Tube ON-TOP of BOTH Brackets (12:59)- Option: Remove Tube Mounting Bracket to make it Easier to bolt to both the EVAP Bracket and K&N Intake (14:11)- Install Heat Shield (15:05)- Bolt the Heat Shield to Car (15:24)- Install K&N Air Filter with Provided Hose Clamp (16:18)- Install Crank Case Vent Hose with OEM Clamps (17:01)- Final Step! Reconnect Negative Battery Terminal (18:00)- Let's Start The Car! (18:46)- Test Drive 1 (20:01)- Test Drive 2
DTA SCION Xb 2JZ DRIFTING - ROGUE STATUS
PATRICK MOURDANT GETS THE DTA SCION SIDEWAYS AT WILLOW SPRINGS CALIFORNIA. VIDEO BY JASPER WATTS