'04-'08 Colorado/Canyon ABS sensor install
Learn how to properly install an ABS wheel speed sensor on a 2004-2008
Chevy Colorado or GMC Canyon hub, and understand why the ABS sensor cord is
not already installed on the wheel bearing assembly.
2007 Chevy Colorado blower fan resistor and wiring harness replacement
Update 12/19/2014 - over three years since I made this video and still
working fine. Other stores have started carrying repair parts now too
including Advance Auto Parts, be sure to read the comments!
Update 11/18/2013 - part number from gmpartsdirect website is pk15218254.
Over two years since I posted this video, blower fan still working great!
2007 Chevy Colorado blower fan resistor and wiring harness replacement,
With much help from coloradofans.com forum
If you like this video, you should check out my awesome roller derby team,
www.battlefieldrollerderby.com, and like us on Facebook. ;-) (was
How To Install Replace Wheel Hub Bearing Chevy GMC S-10 S15 4x4 Part 1 1AAuto.com
1A Auto shows you how to repair, install, fix, change or replace a worn
out, vibrating or groaning front wheel bearing hub. This video is
applicable to 98, 99, 00, 01, 02, 03, 04, 05, 06, 07, and 08 Chevy S-10
Blazer, 98 to 04 S-10 Pickup Truck, GMC Jimmy or S15 Sonoma models. When
your Hub starts to go bad it will make a humming or grinding noise that
changes pitch or volume when you turn.
Prueba Chevrolet Trax / Tracker 2015 (Español)
Prueba de manejo en español del Chevrolet Trax 2015. Van a notar algunas
"imperfecciones" en este video, ya que tuve que hacer todo el trabajo solo
y en muy poco tiempo.
How To Replace a Front Wheel Drive Axle - EricTheCarGuy
If you start to notice your FWD vehicle clicking when you make a tight
turn, you might have an issue with the outer CV joint. If you make a right
turn, it's usually the left side that's bad and vice versa. Most axles are
easy to replace and the one depicted in this video is fairly typical of
what you run into. The main differences come in with how the lower ball
joint is attached. I think this part will give you the most trouble. I
often get asked about what to torque the axle nut to. To be hones, I don't
know. I've only ever run them down with my impact. I've never had an issue
doing it that way and I don't think you would either. Just be sure to stake
the nut or install the cotter pin and retaining clip if it has one. If
you'd like more information on how to deal with suspension noises, check
out this article I wrote on the topic.
Video on CV boot replacement: http://www.youtube.com/watch?v=-S-ofMoWsr0
The best place for answers to your automotive questions:
Information on Premium Membership:
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.