Seafoaming 2007 Chevy Colorado 3.7L I5, 12.17.2011
Man it was cold outside that day! And I could really use an extra hand, lol. ;-p
If you like this video or found it helpful, please check out my awesome roller derby team, East Coast Devastation, at www.ecdrd.com. Thanks!
HOW TO use seafoam properly
this demonstration is explaining how to use seafoam properly thru the brake
Booster vacuum line. notice how this
motor is very poorly kept up on maintenence. notice the motor knocking
before the shut off. the only reason y Dave Martin let us seafoam this
truck was to see all the smoke pour outa his filthy disgusting dirty ass
Throttle body cleaning 2004 GMC Canyon
After reading online how to do this, i decided to out my throttle body on
my 2004 GMC Canyon and clean it. Having never done this before, it was
pretty easy and I am saving a lot money by doing it myself :)
How to Seafoam your vehicle (Also called Top Engine Clean)
This is a carbon deposit cleaner that when used can help eliminate the
carbon deposits that build up in the top end of your engine block. I
perform this about every 15,000 miles on my own vehicle.
Steps to seafoaming:
1. Bring your vehicle up to normal operation temperature
2. Separate seafoam canister into 3 equal parts (one will be for sucking
through a pvc line or brakeBooster
line, one for gas tank, and one for putting in the oil filler cap)
3. Locate the PVC valve that runs through the intake manifold, for this is
where you will initially suck 1/3 of the seafoam canister through.
(If PVC is non accessible then you can use your brake Booster line in the same manner.)
4. Once engine is at normal operational temperature, have another person
sit in the drive seat and bring the engine RPM up to around 1500.
5. Pull your PVC off (or brake Booster line) and start slowly sucking 1/3 of
the seafoam in through either of these locations. Be cautious & steady
handed, you don't want to stall the engine out.
6. Once you've sucked all of the 1/3 portion up turn the engine off &
replace pvc or brake Booster to its
7. Once engine is off, unscrew your Oil Filler cap & pour 1/3 of the
seafoam in as if it were oil.
8. Unscrew gas cap and put the remaining 1/3 seafoam in.
9. Leave the car alone for 15 minutes.
10. Come back to the car and start it up, let it idle for about 10-15
seconds and then BRING ENGINE RPMS TO A STEADY 2000-3000RPM for no more
than a couple minutes.
(major revving or fluctuation can knock carbon deposits loose so please
keep a steady foot)
11. Once this is complete, take your car for a 10-15 mile drive, while
doing so make sure to bring the engine through its total rev band spectrum
to make sure all the carbon deposits have been cleaned out.
12. Once the drive is complete, bring the car back home.
13. CHANGE YOUR OIL & FILTER & SPARKPLUGS WITH KNOWN GOOD OEM SPEC PARTS.
(The reasoning behind this is that the seafoam lowers the viscosity of your
oil, thus weakening its ability to control wear on your engines major
mating surfaces and your plugs get buggered up with carbon after this
tuneup due to the carbon coming loose during the tuneup.. So an Oil/Filter
change & Spark Plugs are a must after seafoaming is complete
14. Tune Up is complete!
Quick Tip-Throttle Cleaning - EricTheCarGuy
This one goes out to BowlingBallOut who posted a question about a sticky
throttle on his Saturn. It was a great question so I decided to make this
video in response to it. There are many different configurations of
throttle assemblies but for the most part if you have a throttle that is
sticking you might be able to fix it using the procedures in this video. I
am aware you may not able to purchase spray throttle cleaner in some states
now but I'm sure they have some alternative available at your local parts
One very important note here is that if you have a drive by wire throttle
(DBW), then I do NOT recommend this procedure. If you perform this
procedure on a DBW throttle body you may need to have the throttle reset in
order to get your engine to idle or even start. I only recommend this
procedure if you're trying to correct a problem with a sticking throttle.
If you have idle problems, I recommend you check out this article on my
The best place for answers to your automotive questions:
Information on Premium Membership:
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
Dumb Things NOT To Do To Your Car
Scotty Kilmer, mechanic for the last 43 years, shows some of the dumb
things he's seen people do to their cars. Visit Scottykilmer.com for
answers to all your car questions.
Chevy Colorado in snow
COlorado Up snow hill, fail attempt. Keeping in mind i do not have the
leveling kit on it that is sitting in the truck and my super swampers. the
2nd er 3rd try I put it in 1st just to see what happened.