95 Dodge neon - All motor- crane 18's - 2.4 swaped - Apexi Safc neo
1995 neon sport with swapped in 2001 2.4L, crane 18s, Aem adjustable cam
gears, crower valve springs, 60mm gasket matched throttle body with bored
and gasket matched intake, headman header, 2.5" header back mandrel bent Exhaust split to dual at the rear, pt
clutch,3.94 tranny, 3L intake, msd ignition, s-afc neo, Accel wires, afx
wideband, short shift, Plx kiwi( i mistakenly called it afc kiwi),solid
front and bobble mount, filled side mounts, chrome coolant overflow tank
and stainless vacuum and coolant lines.
1996 Dodge Neon 2.0l DOHC Borla Single Exhaust
One of the most hated on cars on the internet. My daily driver, a 1996
Dodge Neon Sport Coupe.
Note: I DO NOT LIKE THESE CARS, NOR DO I LIKE THIS Exhaust TONE!
BUT! This car holds alot of sentimental value to me since I grew up with
this car. The car was handed down to me. I, myself, have done a significant
amount of work to this car.
-Replaced head gasket
-Replaced timing belt
-Replaced Intake manifold
-Replaced clutch (Heavy Duty F1 Stage 1)
-Both front and rear shocks
-All gaskets replaced
-Put in 2005 black sxt seats
-Changed over to 2005 sxt rims.
What you are seeing here is a borla single exit Exhaust muffler on a 2.0l DOHC stock engine at
idle and various rpm's with the cat converter and a resonator tip. IMO this
sounds bad at anything above 1500 rpm's, idle sounds fine. The reason I
went with this muffler was because I was trying to replicate the SRT-4 Exhaust tone.
I happen to love the 03-05 SRT-4 Neons, mainly because I see how much
potential they have, as well as having a good looking body.
Dodge/Plymouth Neon Flowmaster Cat Back Exhaust
Before anyone says anything, the car is warmed up. It was driven about 40
miles before this was taped. Also, sorry about the Exhaust vapor. It was a little chilly.
This is the full cat back Exhaust made
by Flowmaster for the 1st gen Neons. Its a 60 Series muffler and a
Flowmaster resonator. Video is of start up, revs, and a take off.
The mods on the car are a custom 3.0 intake, a Modern Performance
underdrive pulley, and the Flowmaster car back Exhaust.
2003 Dodge Neon SXT Magnaflow Catback dual exhaust
This is my 2003 Dodge Neon SXT with my Magnaflow catback Exhaust and I am doing a sound test so the other
peeps on NastyNeons.com can hear what a 2.0L sounds like with the Magnaflow
since some of them would like to hear it here is the vid.
I also have a CAI, UP, MSD coil, MSD wires.
1995 Dodge Neon With Broken Exhaust Pipe
Hit a bump on my way home from a friends and shes really loud well alot
louder then it used to be but the video pretti much shows itself and this
is also back a couple months compared to my other video