When you leave a car show... do this!
Stumbled across a Hotrod show... We were lucky enough to catch these beast as they pulled off and wowed the crowd! My wife was even impressed
Ken Jones - 69 Chevy Nova 383 - Launch Street Radials 2
Before the nova was painted (black) and restored 383 Stroker: (633hp/577tq @ fly) 1969 Original SS 350 Block - 4 bolt main (3970010 cast numbers) - block had been resin filled for strength Eagle - 4340 Forged 3.75" crank (this is an actual 383 specific crank, not a 400 crank milled down to a 383) -Knife Edged and Lightened Eagle H-Beam 4340 Forged Rods (6" rods) JE 4340 Forged Pancake Pistons (full floating pins and Nitrous reliefs) (11:1 Compression = Runs just fine on 91 octane pump gas, but loves 103 octane) - Pistons were Ceramic Coated for Nitrous but nitours has never been run on it. (been wanting to but never got around to it) 64cc Edelbrock Performer RPM Heads (Aluminum) -Fully ported and port matched to the intake and Exhaust -Valves Sizes increased from 2.02/1.60 to 2.08/1.60 -Rev Kit / K-Motion Springs -Comp Full Roller Rockers Holley Strip Dominator Intake Manifold -Port-matched to heads Holley 830cfm Mechanical Double Pumper Carb (re-jetted with jet kit included) -fuel pump is mounted right next to the Fuel Cell and is fully plummed with dash 8 AN fittings and dash 8 steel braded fuel lines. All Transmission lines are done the same way as well Iski Cam - Solid Roller Cam - .602/.602 lift 300/300 duration with 1.6' rockers = .642 final lift Ignition: MSD 6AL Box with changeable rev limiter chips MSD Distributor Griffin 2 - 1 inch core radiator Black Magic Electric Fan Remote Trans Cooler with onboard electric fan Entire assembly has been blueprinted, matched and balanced to each corresponding part. Exhaust: Hooker Supercomp Headers Dual 3" Tubes Dual 2 Chamber 50 Series Flowmasters (this setup sucks... get the Borla XR1s instead) Drivetrain: TH 350 Manual Valvebody Race Transmission Beefed up Driveshaft by Whittier Driveline 3.73 gears with a mini spool in video, then switched to 4.56 minispool, but that was too much, now its got a 12bolt posi 4.11 Heat treated axles Rear-End was a 10-bolt (sucks..) now 12 bolt. Multi leaf springs and lift bars 4000 Stall with anti balloon plates for Nitrous
1971 Nova SS 454
It just a 1971 Nova SS 454