2004 Toyota 4Runner Transmission Fluid and Filter Change (Part 1) -EricTheCarGuy
Visit me at: http://www.ericthecarguy.com/
Discussion about this video:
To be honest if I were to do this job again I would just change the fluid
and leave the filter alone. It's much less of a headache and you won't
have to worry about the Exhaust which
would be the most challenging part in my opinion. Aside from that it's not
likely a filter change will have any real benefit since it's a closed
system. In addition there is some speculation as to what the service
interval actually is for the transmission fluid and filter is. Lastly be
sure that you have some sort of pump to get the fluid into the transmission
before you get started because as I show in the video there is no dip stick
for this transmission that you can fill through. You also need to be sure
to use the proper fluid, I've got my fingers crossed that the MaxLife that
I used will hold up fine, so far it's been about 2 months since I shot this
video and it seems to be fine. In all it's not a bad job there are just
specific procedures that need to be followed to be successful with it.
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
BEST of Start Up sounds!! More than 70 Exhaust Sounds!
To celebrate my 600th video, I have made this compilation: probably all the
start up sounds from supercars I've recorded in the past years. It's the
largest start-up sound compilation on YouTube right now! I have put them
together in one video with more than 70 start up sounds!
What's you favorite start up sound? Let me know by leaving a comment
1st Channel: http://www.YouTube.com/GUMBAL
2nd Channel: http://www.YouTube.com/GUMBALTV
3rd Channel: http://www.YouTube.com/CarChannelClassic
Thanks you for watching my videos. All feedback on my videos are
appreciated! Don't forget to like the video and subscribe to my channel.
More videos coming up!
1998 Supercharged 4Runner.m2t
This video provides an overview of modifications made to my Supercharged
1998 Toyota 4Runner which has 198K miles on it
How to Remove Stubborn Toyota 20R - 22R - 22RE Crankshaft Pulley Bolt 1979 - 1995
A long (but detailed) video on the tips and tricks I've learned over the
years on how to remove stubborn crankshaft pulley bolts on Toyota 22R
series engines. (22R 22RE 22RET)
By far, the best way would be to have the SST (shop specific tool) that
Toyota recommends, but not many folks (me included) has one of those in
their garage. This is a video of some of the tips and tricks that I've
learned over the years on getting this sometimes EXTREMELY stubborn bolt to
The most common reason that you need to be able to get this bolt out is so
that you can access the front main seal on the front end of the crankshaft.
Most older Toyotas develope an oil leak through the seal. Oil works past
the worn-out seal and then gets flung around the front of the engine and
engine bay by the crankshaft pulleys. It's really a pretty easy fix for a
very messy problem...if you can get the crankshaft pulley bolt off in order
to access the seal.
How to remove the intake and change the gaskets on a Chevrolet Vortec 5.7L 350.
How to remove the upper and lower intake manifolds on a GM 5.7L or 4.3L
engine. This truck's lower intake gaskets had sprung a leak and I needed to
change it. When changing the intake gaskets, it's not necessary to remove
the upper intake, but I showcased how to do it anyway for people that need
to change the spider injectors or the upper seal.
4runner Off Road
Various off road trails in our stock 2006 4runner.
-Lake Como Road
-Handcart Gulch Trail
Your comments are welcome!
1984 Toyota 4X4 Pickup Rumbling Exhasut & Engine Rev 4WD 22R with Updates
Here is a UPDATE of my 1984 Toyota Pickup Truck. I shot this last week
November 29, 2009 around 6:00 pm in my driveway. I have put Dick Cepek 6
3/4 shackles, Pro Comp drop drag link, Trail Gear knuckle rebuild kit,
Trail Gear wheel bearings, Roll Bar, header gaskets, Exhaust pipe, cherry bomb muffler, chrome Exhaust tips, and I Have A Webber Carb On
the Way!! Christmas gift from the wife!
Subscribe to my channel to keep up with the mods I do to the truck and so
wheel'n vids as I post them!
Here is a complete list of mods done to my 84 Yota:
Freshly re-built engine, Detroit Lockers, 3" body lift, 3" Rough Country
suspension lift, Trail Gear 4.88 Creeper Gears, Trail Gear Knuckle Rebuild
kit, Trail Gear Wheel bearings, Pro Comp drop drag link, Dick Cepek 6 3/4"
shackles, new Exhaust pipe and cherry
bomb muffler, 33x12.50x15" Dunlop Mud Rover Tires, Chrome exhuast tips,
transfer case seals, Roll Bar, Mid size/Mild cam "some say a towing cam",
headder, after market radiator, potentiometer thermostatic controlled
cooling fan, Auto Meter Tach, oil gauge, temp gauge, and volt meter, custom
rear tube bumper, General Lee CB Radio "45 watts", Wilson 5000 magnet mount
CB antenna and probably some more I have forgot to list.
Please rate and leave comments! Thanks Eric
How to Remove and Install a Toyota 20R 22R 22RE Distributor
How to remove and Install a distributor from the 20R 22R 22RE Toyota engine
series. You will still need to use a timing light after you are done to
set and fine-tune the timing, but this video will show you how to remove
and replace the distributor and get the inital install correct.
GTA Car Kits - Toyota 4Runner 2003-2009 iPod, iPhone and AUX adapter installation
installation instructions for iPhone, iPod, iPad, AUX, mp3 adapter into
factory stereo of Toyota 4Runner for model years 2003, 2004, 2005, 2006,
2007, 2008 and 2009. After installing the car kit you would be able to
listen to your iPod or iPhone through your factory stereo speakers and
control your music through controls on the factory radio along with
displaying the song name. The kit will charge your iPod/iPhone.
You can use these instruction for removing Toyota 4Runner factory stereo.