1982 Chevy Stepside
Freshly Built 350 small block with less than 100 miles on it. The motor started out as a 355 horse ZZ4 crate motor. That we tore down to the shortblock and put on Dart heads with 2.02 vales, Victor Junior single plane intake, Comp Cams roller rockers, 750 Edelbrock carb, and a 550/550 solid roller Comp Cams cam. As for the truck it has a Dana 60 front and 14 bolt rear with locker. turbo 400 trans and has 10 inches of suspension lift with 38.5 Super Swampers. And line lock for fun. This video was taken right after new Heddman Headers and Flowmaster single chamber mufflers were just put on.
84 chevy prt 3
the ol chevy got a big block. ya its a zz454 with open headers.
chevy truck restoration
My 1982 chevrolet scotsdale pickup, i bought for 500 bucks. Put a 1993 gmc
fuel injection motor and complete wiring harness with computer from the 93
pickup in it, 4 inch rough country lift, new front fenders, rocker, cab
corner, and rear fender panels and hood scoops from lmc truck. I did
everything myself, including the sunset red painjob, in about 4 months
using every free weekend i had.
You will have to play "My Friend Of Misery" by Metallica for the music that
is supposed to go with this video. January 17th Poker Run. I took my
Stepside on 42" Iroks, Dwayne with the Suzuki Samurai on 36" Iroks, Travis
in the 4-Runner on 35" BFG's, Marvin and Sam in the '72 Chevy, Tim in the
Cherokee and Randy in the Ford Flatbed. Travis, Dwayne and myself were the
only ones to make the loop. I had the largest tires and got around best (of
the trucks). Dustin and Richard were there on 4-wheelers and Dustin's
4-wheeler had tracks which went everywhere. I could almost go wherever I
wanted with the 42's on the Stepside, it just wasn't very fast breaking
350 Chevy Small Block Choppy Idle in a 76 K20 Chevrolet
357ci Chevy using Comp Cams 286H. Ram truck pulling Clutch Disk, Pressure
Plate, Billet Flywheel inside a Lakewood Bellhousing. Lots of other fun
stuff inside the engine. 40 Series Flowmasters channeled through 3" Exhaust tubing. Sounds decent for a 10
year old engine that has seen lots of abuse.