Valve cover Gasket change
This is how we change a valve cover gasket on a 2000 Toyota Corolla.
Tools we used were a 1/4 drive socket set
Soft blow Hammer and a screwdriver
And 1 new gasket
We used an aftermarket gasket set that came with two round grommets. We
ended up not using them because it would cause the cover not to seat
I was behind the camera for this one.
If they can do it SO CAN YOU! NO SPECIAL SKILLS NEEDED
Thank you for watching
Mahalo I am now a Fullscreen Partner to apply click here
Car Falls Off Lift!!!
A vehicle at a garage slipps off the lift arms and some how manages to get
stuck 1 foot off the ground. Somehow the vehicle suffered very little
damage. Car gods were looking out for this one.
*update* This is how the vehicle came to it resting spot*
Engine and tranny were getting ready to be installed into vehicle, Hence
the craddle sitting on jack stands. While lowering the vehicle down to
install the craddle back into vehicle no one noticed the pole jack still
supporting the rear end of the vehicle until it was to late. This is the
result of what not paying attention does. 1 man almost looses an arm while
holding the strut up right to slide it into position... Dont work in a
Royal mail goes that little bit further to deliver your mail
Truck On a Lift Flips Over
A mechanic is working out a truck when all of a sudden the lift collapses
and turns the truck on it's side.