Dodge Challenger SRT8 392 vs. Shelby GT350
Video of our muscle car showdown between the 2011 Dodge Challenger SRT8 392 and the 2012 Shelby GT350. Only 1492 Challengers like this one will be built, and Shelby has a cap of 2200, with only 500. Read the Dodge Challenger SRT8 392 vs. Shelby GT350 photos and comparison test here: http://roadn.tk/28
First 2011 Mustang GT 5.0L 4V To Run 10's N/A!
Evolution Performance, Inc. - 2011 Mustang GT 5.0L 4V Runs 10.97@124MPH All Motor with a 1.49 60ft!
This time around we wanted to make a 10 Second Pass Naturally Aspirated.
To make this happen we had to get much more aggressive with the Tune and shed off some weight!
Read about this car in upcoming issues of 5.0 Mustang and Super Fords Magazine!
Go To www.evoperform.com to purchase Cold Air Intakes, Custom Tuning, Longtube Headers, Axle Back and Catback Exhaust Systems, Off-Road and High Flow Catted X-Pipe's, Suspension Kits, Race Wheels, and Much, Much More! Online Store Open 24/7 - www.evoperform.com
The Best Burnout EVER!!!!
$300.00 special catching HELL!!! At the 2011 Burnout party!!!
This vehicle was bought to finish the show with a bang!! This was done in front of the house on a PRIVATE road and IF YOU DON'T WANT TO SEE A BURNOUT DON'T CLICK THIS LINK!!! And don't ask WHY?? If you want to see pics of the road after the burnout go to my channel click on website!!!
Messed with a wrong mustang...
it ended up being supercharged, modified to look like a sleeper gt, even had the stock Exhaust tips but you could clearly see the huge dual piping behind them...lots of respect. Driven by a senior citizen, no joke. BTW for ppl that think we were in a base 300 video response attached is the same car. More videos of this SRT can be found on my channel.
RockE's 800hp Dodge Charger SRT-8 Start-Up and Walk Around
Start-up and walk around of the black beast.
This is NOT my car. Any assumption made thinking that it is, is WRONG! I posted these videos of the Charger for the actual owner - a former coworker.
Ford Shelby GT500 vs Dodge Challenger SRT-8
Motor Trend comparo between Ford Mustang GT500 and Dodge Challenger SRT-8. This is for those of you complaining that the Camaro SS should have been stacked up againt these two. When (or if) the Z28 comes out then we'll see who the true muscle car king is.
Turbo Mustang GT vs. Kawasaki ZX-10
TECHNICAL SPECS LISTED BELOW:
turbo System:
Rusty's Total Performance Single turbo System
1-3/4" Primaries, 2.5" x-over pipe, 3" IC piping. All hot parts are coated with the HPC 2000^ Black coating.
Mental Addiction Motorsports Intercooler
HKS blow off valve
Tial 35mm wastegate
Engine and Management System:
Dart Block 316 ci built by 1st Performance
AEM Engine Management System P/N 30-1400
Single channel wideband
Additional Sensors:
AEM 3.5 Bar MAP sensor, 30-2112
Boost controlled by AEM
G.M Boost control Solenoid part# 1997152, $13.66
G.M Pigtail for the Boost solenoid part# 12102747, $14.58
http://www.paceparts.com/
Injector Resistor pack, 8, 8ohm 25Watt resistors, purchased from Capital Electronics: 602-252-5897 used to drive low impedance injectors with AEM.
Cam Motion Custom Cam, 217/211 .530/.513
Induction and Fuel:
Accufab 75mm TB
Reichard Racing Upper Intake BARELY clears under the stock hood. (Intake height from the lower to the highest point including 1" spacer is 6-3/8", I am using convertible motor mounts)
1" TFS-R intake spacer (required with this intake to clear fuel rails)
Reichard TFS-R air-gapped Lower
TFS TW heads w/ 185 CNC port by TEA
Cometic Head Gaskets
Crane Pro Magnum 1.6 rockers
X2C Motorsports 1000hp Fuel System
Paxton FPR
Aeromotive Fuel Rails (rubs all over the stock distributor cap.)
Siemens-Deka 83# injectors
Ignition and Exhaust:
3.5" downpipe
3.5" U-pipe that connects to factory style 2.5" cat back system.
Summitt 2.5" GT tailpipe kit
2.5" Dynomax Ultra Flow Mufflers
MSD 6AL
Stock Coil
AEM 2 step
Tranny and rear:
Tremec TKO900 from Mod Mustang Racing (I sheared all the teeth of 3rd gear in my old standard TKO)
Lakewood bellhousing
Ford Aluminum Driveshaft
31 Spline Moser axles (SN95 length, makes wheel/tire selection a PITA!!)
Detroit Tru-trac
3.27 Gears
Trick Flow diff cover
McCleod Twin Disk Clutch
Stock cable, Steeda quadrant and firewall adjuster
Metco Driveshaft Loop (avoid the Lakewood!! I had one, it is too small in most cases)
Suspension and Brakes:
Tokico 5 way adjustables
H&R Road Race Springs, 265# rear
13" rotors w/ PBR Cobra calipers
D&D Tubular A-arms
X2C Motorsports Coil over kit with 300# springs
??? Tubular K-member, I don't know who makes it, I bought it cheap and used.
Flaming River manual steering rack and shaft
95 GT rear brakes
93 Cobra Master Cylinder
SVO Prop valve
Maximum Motorsports CC plates
Maximum Motorsports n/a Lower Control arms
Stock Uppers
Airlift Airbags
Tires and rims:
1999 OEM 17x8" Cobra Wheels
Nitto Drag Radial 245/45/17
Bogart Drag-On Stars for the track
Body:
Custom cut front bumper
Saleen Wing
LX Taillights
Race Weight: 3425#
Other:
6 point custom chrome moly cage by Southwest Custom Trucks
Faze gauges
Custom Gauge panel by www.gaugeplates.com
Lincoln MKVIII Fan controlled by AEM
200A 3G alternator
Custom aluminum fan shroud that houses the Mark 8 fan, made by Mental Addiction Motorsports.
Custom emblems by www.gaugeplates.com
Let the whining continue... lol
FAST CAR vs. FAST BIKE - ON THE HIGHWAY :)
turboMustangs.com Project Car vs. modified Kawasaki ZX-10
1st run... The bike stole "the break".
2nd run... They started even the bike hit the rev limiter a few times but then they evened out.
3rd run... Bike wins by about 3 car lengths.
4th run... Bike bounces off the rev limiter & he gets rolled by the stang.
5th run... They are basically dead nuts even on this last run... it's pretty crazy :)
