XR6 Turbo @ Powercruise 2010
Taipan Motorsport is very proud of both our pit girls (Marta and Camilla)
for there outstanding efforts over the weekend at Powercruise Syd 2010.
Hope you enjoyed the ride Marta. From all the team at Taipan, thanks girls
For those wondering, I did crank the Boost above our Dyno shootout effort just for
Marta, wouldn't you?
Massive shout out to the Team at MR HDT, you guys are the Big Guns of the
event not the cars.
Special thanks to Troy and Michael from turbo Smart, your products are the reason Marta
had such a good time.
Special thanks to CV Performance, your the man Con.
To all the Team at Taipan, Michael, Damian and Scott, funs over, back to
twin turbo xr8
I have taken the NOS off my std short block 5.0l xr8 and put twin turbo's on it , with only 6psi of Boost it runs just as fast down the 1/4 as it
did with a 100shot of nos. ran 11.11 @ 123 mph first meeting out, made
470rwhp on 6psi
Wicked Worked XR6 Turbo!
We spotted this beast plodding around the city, was VERY much a sleeper,
the bloke even pretended to be slow till the first run on this video,
may want to skip ahead to 0:40 as the sound of the wind is horrible!
How to test for a bad head-gasket
For more info. on my eBook go to www.scannerdanner.com
This is a review of a test procedure I have in my ebook. Section 1
"Universal Testing Methods" page 13. There are other ways to do this test.
I am just showing the one I use the most when looking for a bad head
EB falcon cylinder head reassembly-how to + a small blooper!!!
as per title, YES I DROPPED A F&%KING CABLE TIE INTO THE TIMING CASE!!! IT
WILL BE OKAY(IT'S ONLY A VERY SHORT CABLE TIE), SO DON'T CARRY ON ABOUT IT.
IF YOU HAD DROPPED SOMETHING METAL INTO THE T/CASE, THEN IT WOULD BE A VERY
BIG PROBLEM(which would require a lot of dis-assembly)!!!
How to Test Head Gasket
** Please see my other videos on this topic* Thx!
This video is intended for those who would like to know how to confirm a
damaged head gasket on a vehicle prior to making the decision to invest a
lot of money for repair. My apologies for the camera focus- next video I
will pay closer attention, but the information needed is viewable. Further
research should be done on the risks of overheating to the engine block and
such. This video is meant to simply show a 'how to' on the test method I
used quite often when professionally working on vehicles, the results of
which are based on chemistry and industry-standards of the time (1990's).
I hope you find this video useful. RI.