Bisimoto 700whp D16Z 1990 Honda Civic Turbo Wagovan
Our impromptu, yet detailed look at Bisimoto's 700 wheel horsepower 1990 Honda Civic
turbo Wagovan, which is powered by a
D16Z engine and a huge turbonetics
BTX6565 ball bearing turbo. Shot on the
fly at a car meet using our Canon handheld camera; completely unedited
(except for the addition of our web address).
For more photos, check www.MOTORMAVENS.com
92 Accord Turbo Compilation
a collection of clips from my CB7 accord G22 turbo. 530whp pump fuel 18psi Meyagi Tuned!
* motor is sleeved with an 88mm bore, CP/Carrillo internals, fully built
and ported head, 1200cc injectors. Tuned on CROME. Car was built/tuned by
myself on a budget, no sponsors (no mommy and daddy $) Car is built to take
the abuse, its been running strong for 2+ years, seeing rev limit every
day, and all clips that were shot on the road are on 17" street tires.
Track clips are on 26" MT drag radials.....
Thanks for watching,
Accord Wagon Turbo
1994 accord wagon,H swap along with the 5 spd swap. 459 miles on this motor
so far still breaking it in. just a quick vid of how it runs so far.
Wagon Attack 2
A short film about a rusty Honda Civic Wagon and a dude that loves deals.
Love Wagon's, and the 80's? Check out the Wagon Attack 2 Tee
How To Pull Honda Codes Without a Scanner -EricTheCarGuy
Link to code explanations:
Honda ABS Codes 1994-1997:
Honda ABS Codes 1998 and up:
Visit me at: http://www.ericthecarguy.com/
Discussion about this Video:
I feel like I should have made this video a while ago but the opportunity
never came up. Since I had this RL in my shop that had a check engine
light AND an ABS light I thought it was a perfect opportunity to put this
video together. I get asked all the time about my 'special tool' and it's
really nothing more than a Honda 2 pin connector with the input wires
soldered together. These connectors might be harder to find than you think
but if you run across a junk honda and one of these is on the harness grab
it. Even if you don't have the tool a paper clip or piece of wire will do
the exact same thing so don't sweat it if you don't have the tool because
shorting the connector is all you need to do.
I hope you find this video helpful.
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.