More Videos...

My Subaru Leone RX
A little video of my black RX. http://www.nettiauto.com/subaru/leone/4869357?sitelang=1 SOLD!

Subaru Leone turbo dyno run
Fuel cut or insufficient ignition. edit. Is it fuel cut.

Subaru RX off-road 1
Ej22 engine. Full time 4wd, center diff lock 1.59 low range, 3.700 final ratio. 6cm bodylift. 5cm suspension lift. 31x10.5 R15 tyres https://picasaweb.google.com/109434264633593647600/SubaruRX

subaru ea 82 first start on floor ...
subaru ea 82 engine for my 72 beetle 1200 cc

#08 EA82 Timing Belt Procedure (Subaru GL DL GL-10 Loyale XT RX) L-Series
The Art of Subaru Maintenance #08 EA82 Timing Belt Procedure (Subaru GL DL GL-10 Loyale XT RX) L-Series

subaru leone snow offroad part2
engine 1,8; full-time 4x4, diff lock, lift 2', wheels 14'

Subaru Leone RX 0-140km/h
Too high revs. Normal mods. Bad gearbox. SOLD! This is a video of the same car http://www.youtube.com/watch?v=46f2CQXp44c

subaru engine removal
subaru engine removal

Subaru WRX EJ205 Engine Rebuild Part 4
Anthony @ DIYautotech taking you on a Multi-Video Series of how to rebuild a factory subaru impreza wrx from top to bottom. This video features accessory removal & tricks and tips on custom ways to remove certain parts WITHOUT the use of EXPENSIVE factory subaru tools. This video will teach you how to split a boxer pancake engine in half.

subaru loyale engine rebuild
piece of shit car

Subaru Leone Turbo exhaust sound
2,5" Exhaust pipe with one muffler.

Subaru leone offroad

Subaru Leone Coupes WRX STI
Here are 2 coupes that I have built up over the last 5 years. Sadly the blue one has been sold. Can only drive one car at a time. The blue is n/a EJ20 Impreza running gear under the coupe shell. The red car is my current ride with full 94 WRX running gear under shell.

Subaru Leone Turbo
Enjoy this ultimate Subaru GL10 See more of this great build here http://www.toronto-subaru-club.com/forums/member-journals/160929-leone-turbo.html

Subaru Head gasket installation instructions
Subaru Head gasket installation instructions for putting your new head gaskets on. Another thing people will usually replace at the same time is the head bolts. I recommend doing this if there has been severe warping of the heads due to severe overheating. Often times the original lead based gasket fails due to age/heat cycles/expansion and the bolts are fine. In this case it's fine to clean the old ones with a wire brush and dip the tips in motor oil and re use them.