67 camaro 406 small block chevy-LAUNCH DOWN THE DRIVEWAY!
Sorry it came late I was a bit busy through out last week so, this is my dad launching his car down the driveway and letting it idle on the driveway. Hope you enjoy the vid, please comment, rate, and subscribe:)
JCG Restorations 1968 Camaro -- /BIG MUSCLE
Tucked away in a small industrial park in Oxnard, CA sits JCG Restorations
& Customs, a moderately sized shop that has built some of the best
performing pro-touring cars that we've ever driven. Now generally we don't
focus in on shops, however when the owners of three of our best test cars
start dropping names, we tend to listen. Originally we descended on JCG to
drive Blu Balz, a stunning 1968 Camaro owned by one Karl Dunn.
However since Mother Nature decided to water the Earth that day, we put our
original plans on hold and got shop owner Cris Gonzalez to give us the in's
and out's of what it takes to make a stellar pro-touring car.
The Ultimate Small Block Stroker Engine Build -- Part 1
Part 2 in this series is here: https://www.youtube.com/watch?v=q_Bu8sEeNFg
The first video in a series building a big inch stroker motor. We're
cramming 427 cubic inches into a small block Chevy with all off-the-shelf
For the rest of the videos in the series, build sheets and even Dyno results, check out
ltimate-stroker/ . Thanks
We're constantly uploading great new videos. Please subscribe so you won't
MORE INTERNET GOODNESS:
WILLIS JEEP MAKES IT ACROSS THE CRAZY EIGHT
Willis jeep with 54 inch tires makes it across the crazy eight at river run
at the Mardi gras ride.
#41 - Most Discussed (Today) - Autos & Vehicles
#63 - Top Rated (Today) - Autos & Vehicles
Chunky Cammed Small Block Chevy Nova FRESH start up
Here is a video of my 73 nova that I have been restoring. Its got a built
350, built th350 trans and locker posi 3:73 rear. All fresh rebuilt. Was
really nice to finally get it running and hear what all that work was for!!
10.5:1 compression, crane cam, 10/10 crank, .030 over pistons, flat top
pistons w/ 4 valve relief, 305 heads w/hd springs, holley headers, HEI
dist, performer eps intake, edelbrock 600 cfm 4bbl.
1972 Nova solid roller 406 SBC
Just finished the build and have some cleaning up and tuning to do still:
-400 sbc .030 over
-stock crank and rods, forged trw pistons
- lunati 60132 cam 243/249 @ .050
- AFR 210cc Heads
-RPM Air Gap intake W/ 1" open spacer
-Pro-Systems carb set up for road racing/Autocross
72 Nova - 408 SBC - Big Cam Idle & Burnout
dex=1 at the track....
406 Sbc - 9.75:1
AFR 195cc heads
Comp Cams Extreme Energy 288 Hydraulic Roller
1.6 Rockers .555/.576 288/294
Edelbrock RPM Airgap Intake
Hooker 1-3/4" Super Comp Headers
Holley 750cfm Double Pumper