The Haycemobile - Build up - Part 1
This is a vid I put together for a mate.
It shows the awesome progression of his car over a clutch job that turned into a full on 4-year build. No holds barred. GT3076R, JE forgies, Eagle rods.
This is going to be a monster.
Stay tuned for part 2, the engine build, the interior and the initial tune.
Music by Deftones - Change (in the house of flies)
JRSC ITR Build Up - Chapter 1
This clip shows the progression of my JRSC supercharged B18c-R DC2 Honda from it's humble beginnings as a turquoise Vti-R to how it look today.
This movie has a bit of a sad ending. Bye bye B18c-R.
Thats ok though, chapter 2 shows the re-power with a JE/Eagle forged B18c and a bit more Boost + methanol :)
Credit to Adam Plews for the initial build, my part comes later
Music by Pendulum - Planet Orion
**** For all the haters of the rear bumper, this video is actually getting pretty old now, the holed bumper is long gone, now replaced by a plain 98 spec. ****
Erics integra build motor rebuild.wmv
(I know my motor sucks, i know it makes no power, i know im a ricer, whatever. if you have crummy comments to post dont bother, just enjoy the vid.) Any way, this is my 96 GSR im rebuilding. im 17 and am using this project car as my grad project. everything has been rebuilt top to bottom. heres what has been done VVVVVVV
Engine (long block) 1996 b18c1 GSR:
Bottom end (rebuilt by Jasper engines 15,000 miles ago):
Crank was checked to be balanced and was true
New rob bearings
New main bearings
Cylinders bored .50
New pistons and rings (11:1 compression)
Cometic complete bottom end gasket kit
New oil pump
New ITR water pump
Block was also decked
New crank pully
Valves and seats were lapped
Spring rebound rate measured------passed
New valve seals,
All new seals
New timing belt (gates)
Dizzy rebuilt: new cap, new rotor, new ignition coil
All new seals and gaskets including vtec solinoid gasket
Vtec noid disassembled and cleaned
New NKG plugs and Wires
Visison Racing adjustable cam gears
Injectors and fuel rail cleaned
Arp Studs throughout top and bottomend
Cometic head gasket
Trans: Y80 non-lsd
New Second, third, and reverse gear
All new bearings
New half shafts (both)
New intermediate shaft bearing
New ACT racing Stage 1 clutch
jdm front conversion build
1st (intro) = borgore guided relaxation dub
2nd = Violin Dance DJ ZURAW
3rd = hardstyle masterz junior
4th = avicci levels
5th = Stand By Me Remix By DJ DeeMarie
6th = Scooter - Maria
gsr turbo build
Here is a clip of my long awaited gsr turbo build. Enjoy, and be sure to check out more track vids @ http://www.youtube.com/watch?v=j0xoYv1gdXU. NTENSE baby!
Special thanks to Gabe Hin for all the help.
------------The car 2 yrs after (2012)-----------
Project GS-R PART I
The begining of my 98 Integra GS-R build.... I've dropped over $6500 in parts alone on the motor and suspension. I've done all of the hard work and labor in my garage and where the car now sits in storage. It's being built for street/strip/auto-x. I'm hoping to get 300WHP when it's all said and done. No H8RS Welcome!!!! I've done this build with my hard earned money and 100s of hours of labor. If u got sh*t to talk, take it somewhere else. THIS IS FOR ALL THE TEGGY OWNERS OUT THERE TO ENJOY AND GET IDEAS FROM.
Civic Build 2008
My newest build ('99 SiR) here: http://www.youtube.com/watch?v=pAgQ9AdrpRY
Build from March 2008 to December 2008
Morgan Page ft. Lissie - Longest road (deadmau5 remix) and the Matrix theme.
Part 2: http://www.youtube.com/watch?v=N5kdimvIG1o&feature=channel_page
progress up to feb 14th 2009
Build thread here:
Me = AcousticAudio
Car was estimated at 190whp@6800rpm at 6psi street tune 9.0:1 compression 0.48 a/r t3/t4 turbonetics turbo.
Coming next year: Eagle rods(new redline 8200rpm) + Wiseco pistons (upping Boost to 14psi), bigger turbo + injectors, Dyno tune + more. Estimated 350whp+
94 GSR JDM Front End Conversion
94 DC2 JDM Front Conversion Video
here's the picture of how the car came out after the paint job!!!
this is how the car looks like after the paint job!!!