Ford Fiesta Mk3 very cold start at -45C
Ignition action starts at 1:30
* I started my Ford fiesta 1.3 from 92 after 3 days in really cold weather.
Temperature with wind chill factor was -45C at that beautiful morning .
Video is long because i decided to warm up the battery first a little and
had no time to cut the video. No gas pedal, only clutch pedal down, because
the liquids were really thick and i didnt want to float the engine
Cold start Ford Fiesta 1.1 Ghia (1990) and drive
Cold start without starter and drive Ford Fiesta 1.1 HCS Ghia (1990)
Avviamento dopo un mese della Fiesta 1.1 Ghia a carburatore; rumore del
motore al minimo; una piccola guida nel parcheggio.
Ford Ka offroad test
Ford Ka car test! Let's test this car its durability!
Ford Ka autotest! Laten we deze wagen een testen op degelijkheid!
How To Remove And Clean A Throttle Body
How To Remove And Clean A 1998 Dodge Dakota Sport Magnum V6 Throttle Body.
You Will Need: Ratchet Wrench, Flathead Screwdriver, Cloth, Gloves,
Carburetor or Throttle Body Cleaner, a Brush and some Gloves. Remove all
the Valves & Components attached to the Throttle Body. Spray completely
with the Cleaner, Scrub it with a Brush to remove any build-up. When
finished, Wipe down with a cloth and let dry for 2 days. Clean & Re-Install
Valves & Components then Re-Install on your vehicle! Please Comment, Rate &
Subscribe. I do not own this song!
Oto-Park.Com | Ford Fiesta 1.6i Titanium (2013)
Güncellenen Fiesta, aşka gelen bir grup mühendisin böylesine mütevazı
bir sınıfta dahi ne büyük bir fark yaratabileceğini haykırıyor:
2011 Ford Fiesta SE 4DR Start Up, Exterior/ Interior Tour
**NOTE** Recieve a free MP3 player to sync with your MICROSOFT SYNC system,
with the purchase of any 2011 Ford Fiesta at Grapevine Ford! ACT NOW
everyone, numbers are slowly becoming limited!!
Video shot with much thanks to Grapevine Ford.
Fiesta heater matrix removal
This video shows how to remove the heater matrix on a 1999 Fiesta 1.3
(Endura-E OHV engine)
The Ka is similar.
Thanks to Ford design, this is probably the easiest heater matrix removal
jobs of any car. I've worked on some cars where the entire dashboard has to
come out just to get to it. This is where the good old Fiesta excels -
cheap to run and easy to repair and maintain. The matrix featured in the
video was removed to flush it through after swapping the heater valve and