Jerry's VW go-kart
Jerry bought the bug to convert into a kit car, but lost interest. In the
meantime he had sold the body so he fixed the chassis up as a big go-cart.
1992 11.5hp Briggs and Stratton Rebuild
My first fully edited video production. Time-lapse of a whole day rebuild
of a 1992 11.5hp Briggs and Stratton Flathead Ride-on mower engine for a
future lawn tractor project.
Made using Sony Vegas Pro 9
Long travel buggy
20 hp b&s pro built 3mm stroker , ported block , head , 60 over ,bigger cam
, alum fly wheel ,double springs ,alum rod & more . Will be changing rear
later to a quad motor and jack shaft set up.All cnc brakes.
Briggs and Stratton Power Built 12.5 HP Flathead Model 28 Rebuild, Teardown / Reassembly PART 1
PART 1.... In this video i'm doing a teardown and rebuild of a Briggs and
Stratton Power Built 12.5 HP Flathead Model 28 Lawn Mower engine. Hope this
series helps you, be sure to watch the other parts. And the last part is
the first start of this motor after being rebuilt (not a complete break in
video, just the first few minutes of running and adjusting carburetor) The
only thing i left out was checking the ring gap clearance, which all you do
is put a new ring in the cylinder use the piston to push it down about a
half inch or so and use a feeler gauge to check the gap on the ring. Use
general safety rules when doing anything like this, it is extremely to
cut/smash fingers at any point. I cut my thumb really bad on the timing
gear on the crankshaft (off camera). Just be careful and use common sense.
Thanks for watching