2013 Ford Taurus SHO vs Porsche Carrera
SUBSCRIBE IF YOU CAN HANDLE THIS AWESOMENESS
This was filmed at Bandimere Speedway in Morrison Colorado.
Elevation is just under 6000 feet above sea level.
Check out Bandimere.com for more info on the track
I make drag racing videos and put them up for everyone to enjoy.
Subscribe if that is something you are into!
2010 SHO vs 2007 Magnum SRT8
Magnum had a better reaction time (.04 vs .19), I caught up with him and
had a better time 12.81 at 107.17 vs 12.89 at 108.21), but because I
started late, it doesn't show that way. I have been running between 12.77
and 12.83 all day, him between 12.79 and 12.98... We had good races,
Mods SHO : Non-PP, Stage 4+ by Livernois, custom Exhaust, Airaid cold air intake, H&R springs.
Mods Magnum SRT8 : Diablo tuned, around 465 hp/465tq
SRT10 Ram 350Z Taurus SHO Drag Racing
Beech Bend Raceway test and tune night. 4/6/2013
rolling burnout ! https://www.youtube.com/watch?v=TeL4p94IIfQ
1 minute burnout here! https://www.youtube.com/watch?v=mFA-Sgck_t8
Ford Taurus 3.0L 12v Timing Cover Coolant Leak Repair
This is my favorite gasket set to complete this job-
If the front cover is pitted here is a complete kit front cover included-
If the water pump is needed this is the one to get-
This is the serpentine belt tensioner tool I use Here-
This is the Engine Sealant I recommend-
In this video I show how to remove the front cover on the 3.0L 12v Vulcan
engine. Coolant leak from the main coolant ports is very common on these.
This can be a very costly repair, with this video I am sure anyone with any
mechanical experience can handle this job with ease.
Tighten bolts in the sequence shown.
Tighten numbers 1-7 to 25 Nm (18 lb-ft).
Tighten numbers 8-12 to 10 Nm (89 lb-in).
Torque Sequence Illustration
13MM Crank Pulley Bolts- 37 ft lbs
Large Center Dampner Bolt- 107 ft lbs
Wheel Lug Nuts- 100 ft lbs
Ford Taurus Rear Drum Brakes Replacement
Parts you need for this repair.
Rear Brake Drums-(check fitment guide)
Brake Shoes-(check fitment guide)
Spring Kit-(check fitment guide)
Wheel Cylinder-(if leaking)-(check fitment guide)
Brake fluid I recommend if replacing wheel cylinder-
Self adjuster kit-(if seized up)-(check fitment guide)
This is the best Brake Cleaner to get all the residue off-
Here is the Brake Dielectric Grease I use all the time-
In this video we do a full rear drum brake job on a 2003 Taurus. Along the
way I share my tips and tricks to make this job as painless as possible.
2010 SHO vs 2010 Camaro SS
In Luskville, west of Ottawa, Canada. Second portion of 1/4 mile was in
bad shape, very bumpy! The trap speed are slower by about 2mph because of
I started late R/T of .349 for SHO and .03 for the SS :
SHO = 12.74 at 108mph (intake, Exhaust, suspension and tune LMS stage 4+)
SS = 12.85 at 110mph (intake and tune)
We ran all day together and I was consistent with my 12,7's, but he ran
anywhere between 12.76 and 13.85, depending on his launch. On that race,
he had a good launch.... As for the SHO, it is AWD,so no excuses. : )