JUST A QUICK VIDEO
1/2 BRIDGE PORTED PLATES BY ERA DE CLERK
ENGINE BUILT BY REWORX
HKS MANIFOLD/SCREAMER PIPE AND turboNETICS WASTEGATE
2x850cc PRIMARY INJECTORS 2x1680cc SECONDARY INJECTORS ON 2ND FUEL RAIL
TWIN PLATE OS GIKEN CLUTCH AND FLYWHEEL
Motec M2R ECU
HKS EVC V
BOSCH 044 FUEL PUMP & IN-TANK SWIRL POT
SEIBON BONNET (KNIGHT SPORTS)
CUSTOM DOWNPIPE, BLITZ NUR SPEC R Exhaust
18" Ultralites 265/35 on rear
Sleeper Status! 330 HP Four Door Review!
Car has been sold!
Get some delicious JerkyXP powers here! COUPON CODE- Thatdudeinblue
For this video review, I hop in on of the most unsuspecting vehicles I have
ever driven-bumper stickers and all. This little four door may look
innocent, but in many ways it packs a punch! As always it was a great time
driving and reviewing it and thanks to Jay for letting me drive this little
sneaky four door.
Like the Facebook for updates!-https://www.facebook.com/thatdudeinblue
Song: AdhesiveWombat - Pan galactic gargle blasters
Free download @: http://goo.gl/EIDU8
FreeMusicSpecialist: Copyrght free/Uncopyrighted/Royalty free Music
400 Horsepower RX-7 in Tokyo
Met up with a guy who has a 400 hp RX-7 when it's running at low Boost. To ensure the longevity of the engine
he's running his T04 turbo at about
12psin (very low Boost). It has 2
apex seals on a bridge port motor. He gave a demo on the freeway and
showed what it can do.
Champions-Motorsports.com RX-7 Widebody 20B
Champions-motorsports.com original show car: 20B powered 1994 Mazda RX-7
wide body. The body kit was made by BRS-Autodesigns and styled after the RE
Amemiya Super GT race car. Seibon Doors and Hatch, RE Amemiya Wing, APR
mirrors and canards. Greddy racing Ti cat back Exhaust with Pettit Racing mid and down pipe.
J-Line Wheels. All work done by Luis Sutton, Robert Mealey, Cameron Worth,
Luis Seijo, Mike Lowe.
Rx7 fd3 first time starting, bad water seal lots of smoke
First start after attempting many times a few days ago with no luck just
managed to flood it. This time i adjusted the idle screw out 1 turn as was
having to use the throttle before to keep it running what after a few
seconds would flood it, plugged the stock ecu back in, span the engine over
at full throttle with the coils unplugged, ecu/injector fuse out and plugs
out to clear the rotors of any fuel, heated my plugs up in the oven at 150
deg c for 10 minutes lol and started no problem.
The smoke from around the turbos is
because i heat wrapped the downpipe and it hasnt got hot before.
Has sat for over 4months without running in what time i slowley carried out
these mods, hks downpipe, hks rs intakes, blitz nur spec cat back, removing
air pump, removing ACV and solenoids, under drive pulleys, replacing all
the vacuum pipes under the UIM with silicone ones, fitting Efini Y Pipes,
hks hard pipes with samco hoses and of corse the Apexi power fc pro with
Lots of smoke in this video where it has a bad water seal. I knew about
this before starting it this time but wanted to check all the vac pipes etc
were good and it would start before looking in to the water prob any
Car is running good compression at the moment but dont know for how much
longer! Min 107 psi and max 115psi
Hopefully what i done above may help some of you others unflood your car!
The ecu fuse is next to the battery positive terminal and is the centre one
of the 5.
Bridgeport Single Turbo FD Rx7
Here is some raw footage that I took at our final photo shoot location
during a day of cruising around and taking pictures of our cars.
Mazda Rx7 FD FD3S Single turboturbocharger Bridgeport Bridge Port
Sick RX7 Takeoff - LOUD
Orlando Cars and Cafe - Watch and Listen to this highly modified Mazda RX7
take off. Originally was filming another car but heard what sounded like
gun shots. Turn around and see this 600+whp RX7 just backfiring like crazy.
Watch and listen as he gets absolutely no traction in first gear and then
just rockets off.
The car was putting down 600rwhp @16PSI of Boost with the potential to put down 800rwhp
at 27PSI on race gas.