Chevy Rescues Ford Pickup in Deep Water, Grayland, Washington
It was about 1:00 PM today 7/17/2010 when a driver and 3 passengers were
traveling south on the Grayland beach. About 5 miles south of Westport. It
is legal to drive on the uppermost part of the wet sand on the beach in
Grayland. They were traveling along the surf line when they drove out onto
a sand spit. The driver drove off the sand spit into a deep trench caused
by tidal action. The impact was vilant enought to send one passenger to the
hospital with a non- life threatining head injury. She was treated by
Grayland Fire Department and South Beach EMS then transported to Grays
Harbor Community Hospital. The male driver and two other female passengers
were uninjured other than being very cold and wet. A very dedicated tow
truck operator, Justin Jones with South Beach Towing raced to the scene and
quickly got to work. Justin along with the driver of the pickup waded
shoulder deep threw the cold salt water, to connect a tow rope to the Ford
Diesel Pickup and pulled the rope with a South Beach Towing pickup breaking
the strong suction of the soft sand holding the partially submereged
vehical in place. Once the suction of the sand was releaved the pickup
began to float as water rushed up the hood and icechests floated about the
back of the pickup. Justin Jones, the tow truck operator worked hard to get
the Ford to dry land however he estimates that the diesel pickup will be a
total loss. A Washington State Park Officer stated that the driver will be
issued a citation however it was unknown what citation he will be issueing.
I do know it is unlawful to drive next to the surf line at low tide do to
that being razor clam habitat. UPDATE 7/24/2010. I just found out that the
lady transported to the hospital sustained a broken neck. I hope she has a
speedy full recovery.
Chevy K2500 3" Tearing up Soil On School Property
-Please Rate, Comment, Subscribe-
Just mudding chris's truck on our school feild.
They got it for our FFA and this is the best thing it has done so far.
His truck has a 3 inch block kit in the rear and the torsion bars cranked
up in the front. stock 350 5.7L
But not a Vortec engine..
Thanks for watching.. Enjoy...
Chevy Pullin Out Ford
One stuck piece of Ford needed a little assistance to get out of "The Mud
Pit" luckily there was a Chevy handy to recover the beast.
Fun Day In The Mud
GMC Jimmy with 4.5" lift and 38" Michelin XML's and Chevy Blazer with 35"
boggers in Arkansas.
The Blazer's clutch decided to go out in the middle of the last hole. The
Jimmy had to drag it out of the hole (after ripping the tow hook and bumper
out of the frame) and through some tight trails back to the main road with
absolutely no help. That thing is a BEAST!! RATE WITH 5 STARS FOR THIS
FORD CRUMBLES IN PATH OF BIG BLOCK CHEVY!!
On the first hole of the day at Louisiana Mudfest, Brian Briggs
(TheMudbogger79) showers down on that skinny. Unfortunately there was
another truck stuck in the path of his roost. While trying to move out of
the way, the entire 4-link setup completely cratered when the driver
spooled up and dumped the clutch. The aftermath wasn't pretty. Too bad it
was the first day!
Louisiana Mudfest near Colfax, Louisiana - April 19-22, 2012.
1996 Silverado details - 505 chevy stroker big block, solid lift cam,
forged crank rods and pistons, cast iron heads with port work, roller
rockers, 10.3 -1 compression, NV4500 5 speed manual transmission, 2.5 ton
Rockwells, 54" Boggers, Profab trasfer case, Front leafs have 12" lift and
10" block. Rear springs have 8" lift, 15" block and shackle flip.
Be sure to check us out on Facebook at Triple-X Motorsports & Outdoors for
all the latest updates!
Muddin In My New Chevy
Me And Some Friends Muddin Down By The River. Getting Stuck And Pulling
Out. This Is Just One Clip Of My 93 1500 With 6 Inch Lift With 35's.
travis's Z71 stuck
My buddys Z71 gettin pulled out a mud hole by a beast tow truck on super
swampers after a duramax, cummings diesel, and powerstroke couldnt get him
out. he was STUCK!
The Ultimate Small Block Stroker Engine Build -- Part 1
Part 2 in this series is here: https://www.youtube.com/watch?v=q_Bu8sEeNFg
The first video in a series building a big inch stroker motor. We're
cramming 427 cubic inches into a small block Chevy with all off-the-shelf
For the rest of the videos in the series, build sheets and even Dyno results, check out
ltimate-stroker/ . Thanks
We're constantly uploading great new videos. Please subscribe so you won't
MORE INTERNET GOODNESS:
How to build HORSEPOWER - Ford 461ci Windsor V8 by Dandy Engines
Engine specialists Dandy Engines building a small block Windsor 461ci
stroker for Pat Staplton. Follow the engine assembly as the guys aim to
make more than 820hp naturally aspirated on regular pump unleaded. Pat
plans on putting this brute of an engine into a Ford Falcon XD/XF Ute. [
Creative Commons music license CC 3.0
Jahzzar - Breaking Bad
Chevy Z71, muddin, BFG MTs, 355 V8, 4x4
playin in mud, in my z71, new 355, and 700r, 32.11.50 BFG MTS, this ditch
is about 4 foot deep, its hard to tell on my IPHONE camera but this ditch
is very deep, mud is red clay very very sticky