Tahoe on Air - Dropped 2 more inches - McGaughy's Drop spindles installed
This Tahoe, as you might know, has Ridetech Air-ride suspension (E3, Shockwave Titanium series). I just replaced the entire front end with all new DJM Control arms (upper and 3" drop lower's), new ball joints, new end link bushings, new bearings - and even though it is bagged and has a 3" drop already, it still just did not sit very low. I decided to go with a 2" Drop Spindle by McGaughy's to get just that little bit more and make it better. It was surprisingly easy to do and really made a difference! I know she isnt laying frame but at least it has a little more flavor now when aired out! Another thing that is great is i can drive with the truck much lower and still have good ride quality!
1986 Chevrolet Monte Carlo SS All Street Project Car
This is my 1986 Chevrolet Monte Carlo SS. I have owned this car for 13 years and it has been in the family for over 26 years. The car has just under 29,000 original miles. The engine and drivetrain is all original as well as the paint and interior. I didn't drive the car much, so I decided to make a few subtle changes, mostly in the stance, so I would drive it more. Just don't care for the stock stance on these cars. For the front I used 2" drop Belltech spindles and 1" drop Belltech springs. For the rear I used OPG 3" drop rear springs. 3" total drop front and rear. I used Belltech Street Performance shocks on all four corners. The wheels are Center Line Retros 18 x7 front, 18 x 8 rear. Nitto NT555 tires 225/45 in the front, 255/45 in the rear. Also for a little more sound, I went with Flowmaster Super 40 mufflers and custom tailpipes. I drive the car a lot now just cause I enjoy it so much more. I didn't cut anything and I have everything to put the car back original if I ever decide to in the future. Thanks for looking!
Truck U Belltech Ford F150 .mpg
Truck U installs Belltech's lowering kit and Street performance shocks on a 2010 Ford F150
2011 f150 stx 5.0 lowered
Bell tech 3,5 kit