My 1925 Ford Model T - How to Start & How to Drive
Enthusiasts Website: http://www.fordmodelt.net/
Facebook Group: https://www.facebook.com/groups/modeltford/
Update 10 Aug 2012:
My Model T has been fully restored, and I've just purchased a pair of
carriage lights which the car was missing. Updated video to come.
"I MADE A MISTAKE!"
55psi only applies to clincher tyres on earlier Model T's. Since mine is a
1925 model and has split rims and balloon tyres, the correct tyre pressure
I imported my 1925 Ford Model T from the USA, not far from Detroit,
Michigan where it was built.
In this video I demonstrate the T's unusual controls and how they all work,
I show you how to start a Model T, and I take you on a short drive at the
The Model T was manufactured between 1908 and 1927, and was know by various
names including Tin Lizzie, Flivver, T‑Model Ford, or just 'T'.
The Model T set 1908 as the historic year that the automobile became
popular. It is generally regarded as the first affordable automobile, the
car that opened travel to the common middle-class American; some of this
was because of Ford's innovations, including assembly line production
instead of individual hand crafting.
On May 26, 1927, Henry Ford watched the 15 millionth Model T Ford roll off
the assembly line at his factory in Highland Park, Michigan.
Ford Model T Half engine
I cut this T model Ford engine in half in 1957 using 11 hacksaw blades.
The only part not cut with the hacksaw was the camshaft as it was too hard
and had to ground through.
1925 Ford Model T First Start
1925 Ford Model T Coupe
This Model T was a Connecticut 'barn find' in April 2012, and had been
sitting since 1976. The car is all original and unrestored and will be
kept as a "driver" in its original condition.
Music Credit: Theme song from Click and Clack: The Tappet Brothers radio
show on NPR.
oil change (shocking) after sitting for 50 years Ford Model A
I bought a 1930 (not 31 like I said in the video) Model A 5 window coupe
all original except for a dropped axle, a Mallory dual point distributor,
some dual electrode spark plugs, four blade radiator fan, 15" steel
reversed center wheels with slicks and a lawnmower fuel tank bolted to the
dash (reasons to believe it was a hot rod). It wouldn't turn over when I
got it so I took the plugs out and poured some Mistory oil in the holes and
let it sit for a few weeks, I turned it back n forth till I was able to
give it a few full turns, checked the oil level, put some gas in it, hooked
up a battery and it turned over fine with the starter but no fire, pulled
out the distributor to find a homemade shaft extention that wasn't long
enough so I rebuilt the distributor, made a new shaft, rebuilt the carb,
and now it fired up! I called Adrian to come over and check it out, he
said, "It sounds good but don't try driving it untill you change the oil".
Since the oil looked to be ok and at the correct level, I drove it up and
down the alley. I called him again to let him know how it went and the
first thing he asked was, "Did you change the oil?" So I got to work, took
the drain plug out and oil dribbled out no matter what i did it wouldn't
drain out so I took the oil pan off and found the oil caked at the bottom
of the pan, lesson learned.... Always pull the oil pan OFF to make sure you
don't run your newly acquired Old motor with a pan full of crud, I hope
this helps,,, more videos of this model A to come so stay tunned! thanks
thanks for the great advice Adrian.
To see it running check http://youtu.be/z5V0oXP8roE
1930 model A Ford
My Neighbor Ray and 1930 model A Ford. He bought the car from a farmer in
1952, upstate New York.
2014 Ford Raptor 6.2L vs F-250 6.2L Mashup Ike Gauntlet Towing Test ( Part 1)
( http://www.TFLtruck.com ) The 2014 Ford SVT Raptor does not directly
compete against the Ford F-250. But in this case both trucks have one
significant thing in common...they both come equipped with the same Ford
6.2L engine. In fact the Raptor's 6.2L V8 is tuned with a few more ponies
from the factory. So how do these two different trucks with the same engine
compare when it comes to towing. We decide to find out by taking both
trucks up the TFLtruck Ike Gauntlet Mega towing torture test in classic
The Ike Gauntlet is a timed run up one of America's steepest highways from
9,000 feet above sea level to the top of the mountain at entrance to the
Eisenhower Tunnel in Colorado. Check out this promo for what's coming up
soon on The Fast Lane Truck.
Check us out on:
Facebook: ( https://www.facebook.com/tfltruck )
Twitter: ( https://www.twitter.com/tfltruck )
and check out our car videos on YouTube at:
The Fast Lane Car ( http://www.youtube.com/user/romanmicagearguy )
Ford 4.6l 3v & 5.4L 3v Camshaft Phaser Knocking Noise Fix
In this video I detail Camshaft Phaser repair on the 5.4l 3v engines but
the procedure is the same for the 4.6l 3v engine.
Torque to 30 ft lbs then an additional 90 degrees.
The crankshaft is always being turned in a clockwise direction until the
last positioning of the crankshaft in which we spin it counter clockwise
Proper positioning of cam lobes for roller follower removal.
RH Bank Cylinder 1-
LH Bank Cylinder 5-
Valve Cover Torque 90in lbs Sequence-
Old LH Valve Cover-
Old RH Valve Cover-
New LH Valve Cover-
New RH Valve Cover-