Drag Dodge Neon SRT-4 2005 Stage 1 -festidrag Mont-Joli
Festidrag Castrol de Mont-Joli, 5 août 2012
13.260 @ 106.89 MPH
60 pi.: 2.118
Dodge Neon SRT-4 2005 Stage 1, Wastegate AGP, BFMIC, CAI, 3po. Exhaust, short shifter, street tire.
Driver: Daryl Lepage
Belle et très chaude journée, ça collais super bien!
Dodge SRT-4 Tribute Video
Here are some pictures of Dodge SRT-4's that I got off cardomain. This
video only took me about 20 minutes so it's not that well edited but there
are some pretty nice looking ones. Enjoy the video and please rate/comment.
700 + HP SRT4 Neon
Big tubo SRT4 Neon running S374 turbo,
8200 RPM redline, tuned with DiabloSport CMR software, built motor, cyl
head, custom camshafts, blah blah blah... email me if you want a list of
mods or want us to build you a car like this!
DIY how to replace thermostat on dodge neon srt4
Notice I am not liable if your hurt/ damage your vehicle or yourself.
Attempt at own risk. A bad thermostat can cause it not to open at the
correct temp cause the car to over heat. No thermostat causes you to not
have a heater because nothing is letting the coolant get warm enough
dodge neon tribute
dodge neon tribute only a 2 to 3 ricers are located on this video rate and
comment and visit 2gn.org
Dodge SRT-4 Tribute
A video on the great srt-4 slideshow and video mix also contains some facts
at the end of the video for the haters. Check it out high quality good
music and a good story on the car.
2005 Dodge Neon SRT-4 vs 2008 Nissan 350Z
25 roll race up to about 130, I knew I was going to get killed but I wanted
to see how much of a difference the 08's are to the older models, and
there's a BIG difference.
the Z's stock with the VQ series motor compared the the old HR shit motors
they had, the VQ is rated about 306hp.
the SRT just has an intake and a wastegate.
Dodge Neon - Front Wheel Bearing Replacement
Replacement of the front driver's side wheel bearing on a 2001 Dodge Neon.
This video Covers the following areas:
Removing the Caliper and Rotor
Removal of the Knuckle Assembly
Pressing out the Hub and Bearing from the knuckle assembly using an
The use of a Bearing Splitter