borla headers and stromung axleback 2002 subaru 2.5rs
stromung Exhaust with borla headers, stock midpipe and cat. first rev at 3k then 5k then 3k again
borlas were bought used from nasioc.com
and the stromung was bought from rs25.com
ebay also makes good headers. the seller is speedyracer.
if you want to ask me a question feel free to PM me on nasioc.com. my s/n there is jet594. I check there more than I do here.
Borla Replica Headers on 2.5RS
I installed the ebay special Borla Replica Headers on my 2.5RS.
I purchased them for $210 shipped
The welds on it are pretty descent. I do not suggest using the gaskets that come with it for they are very thin.
Fitment wasn't TOO bad, however it isn't PERFECT. I had pull them "apart" somewhat to get them to align with the heads. No modifications were needed, however.
SPT Exhaust sounds a little raspy though may have a small leak at muffler.
All in all I got what I paid for and I am not exactly upset with the outcome.
Give me any questions!
Scandinavian Flick, Subaru 2.5RS
Practicing a Scandinavian flick on a gravel chicane. I scrubbed off a bit too much speed here.
Please excuse the raspy sound.
Equal length header + stock catback + leak at a flange = no good.
Subaru Impreza 2.5RS hesitation/bucking
2.5RS hesitation/bucking problem. The IACV, TPS, Fuel filter, Spark Plugs and wires were all replaced.
There is currently a CEL for the front o2 sensor and neutral safety switch. I will update soon after the o2 is replaced.
Subaru Impreza 2.5i Borla Headers driving around
Some noise form inside the car is quite loud. This video does not do it justice, but it is the best I can do. I open the windows and close them probably twice, and I shift around 3k-3.5k RPM for most of the video.
Here is a how-to I made on this
http://forums.nasioc.com/forums/showthread.php?t=1445402&highlight=how+to+install+headers
2002 Subaru Impreza 2.5rs Exhaust
Video of my 2002 Subaru Impreza 2.5rs Exhaust Setup
-AEM Cold Air Intake
-Borla UEL Header
-Stromung High Flow Cat
-Stromung Mid-pipe
-Stromung Single Tip Axle-back
http://boxer4racing.3dcartstores.com/
1999 Subaru Legacy with Borla Header and Vibrant Muffler
Car: 1999 Subaru Legacy 2.5GT (BD6)
Engine: 1999 EJ25D DOHC
Header: Ebay Borla Replica
Cat: Stock
Catback: Vibrant Performance STREETPOWER Oval Muffler w/ 4.5" x 3" Oval Angle Cut Tip (2.25" inlet)
Relevant Mods Affecting the Video: Stock
Daios' Stromung catback
My 2000 Subaru Impreza 2.5RS with just a Strömung catback and welded resonator on the midpipe.
Subaru Impreza 2.5RS Revving
2001 2.5 Impreza RS
Mods:
Cobb CAI
Stromung Axel back Exhaust
Custom midpipe with magnaflow resonator
Borla UEL headers
