Information about Oldsmobile V8 engines
In this video I talk about the "late" Oldsmobile V8 and offer tips on how
to identify them by number.
"Late" in this instance means 1964-1990. Early('49-64) Olds engines are an
entirely different block, etc.
Sometimes my info gets a bit twisted when it stays inside my head for a
while, so a correction is that '77-80 heads are 3A, not 4A. 4A heads are
Also, to clarify and avoid confusion, this...7 A is a 350 head, this...7A
is a later 307 head. You can also tell the difference easily by the ports.
Late 307 and 260 ports are half the size of any other versions.
Trivia: The Olds 403 was used in 1977-79 Pontiac Trans-Am's, but not all of
Of note...the engine in the video is painted the incorrect shade of gold,
which appears to be the Krylon generic gold. The proper shade is slightly
darker and less "glitzy"
Aurora vs Grand Prix GT
I won this one too! Again we were bracket racing, so I had to let off at
the end so I wouldn't break out of my time.
Oldsmobile Factory Tour in 1951 - General Motors Documentary
Singers Lucille and Johnny, whose radio show is sponsored by Oldsmobile,
are invited to visit the Oldsmobile factory to see why the cars are
superior to other manufacturers. While touring the plant, Johnny becomes
concerned that another visitor is a Martian spy dedicated to subverting
1998 Oldsmobile Aurora Start Up, Engine, and In Depth Tour
In this video I give a full in depth review and tour on a 1998 Oldsmobile
Aurora. I take viewers on a close look through the interior and exterior of
this car while showing details, over viewing of features, and noting unique
styling cues to the vehicle itself. I also show the engine and the details
of it, start it up and see how it sounds under acceleration. A thorough
review of this car designed to give others a greater overall appreciation
of the vehicle.
2003 Oldsmobile Aurora Promotional Video
2003 Oldsmobile Aurora promotional Video from a DVD mailer promoting the
entire 2003 Oldsmobile model line. Visit Http://www.CheersandGears.com for
more Oldsmobile or General Motors information and discussions
GM ( Chevrolet or GMC ) 4.3 L V6 Engine Tear Down
This video goes through the teardown process of a GM 4.3L V6. It has been
removed from the vehicle and we take it apart, except for crank and piston
The automobile consist of:
• Fuel System: Purpose is to deliver fuel to the engine. It consists of
the fuel tank, pump, gauge/sensor, filter, pressure regulator and
• Air Intake System: Purpose is to clean and direct outside air into the
engine. It consist of air filter, ducts, air plenum and intake manifold.
• Exhaust System: Purpose is to
direct Exhaust gasses out of
combustion out of engine. It consists of the Exhaust manifold, converters, pipes and
• Cooling System: Purpose is to remove excess heat from the engine. It
consists of water pump, hoses, radiator, thermostat, cooling fan and
coolant recovery tank. Also the oil system serves as a cooling system as
well as a lubricating system. It consist of oil pump, pan, filter and
1. Clutch: Purpose is to connect the engine and transmission together. It
consists of clutch drive disc, driven disc, release bearing, clutch fork,
cable, slave cylinder, master cylinder. There are three types of clutch
systems: mechanical, cable and hydraulic.
2. Transmission: Purpose is to match engine speed to road speed. Two types
used are manual or automatic. These consist of gears, linkages, cables and
converters for automatics. A manual is connected to the clutch by a
flywheel and automatic by a flexplate.
3. Driveshaft: Purpose is to connect the transmission to the rear axle. It
consists of a slip yoke, shaft and universal joints.
4. Rear axle differential: Purpose is to change the angle of motion from
engine to the wheels. It also divides torque between the wheels. It
consists of a ring and pinion gear, carrier, bearings, crush sleeve and
5. Wheels/Tires: Purpose is to provide traction to the road as well as
carry the weight of the vehicle.
Vehicle Control Systems:
1. Brakes: Purpose is to slow and stop the vehicle. It consists of master
cylinder, brake Booster (vacuum or
hydraulic), calipers, drums, pads and rotors.
2. Steering: Purpose is to direct vehicle in the required direction.
Consists of steering gear (rack & pinion), steering wheel, column,
inner/outer tie rods, pump, reservoir, hoses and pipes.
3. Suspension: Purpose is to provide stability and handling while also
providing comfort to the ride. Consists of shocks, struts, sway bars, end
links, springs, trailing arms and bushings.
1: Heating Ventilation Air Conditioning (HVAC): Heats and cools interior
air to passenger comfort. Also circulates outside and inside air.
• Air Conditioning: Consist of condenser, compressor, accumulator
(receiver/dryer) orifice, expansion valve, hoses, evaporator, controls,
actuators and modules.
• Heating: Consists of heater core, valves, hoses and switches.
1. Power Generation: Creates electrical power to run all the electrical
systems. Consists of the alternator.
2. Power storage: Stores unused power to start the car and supply voltage
to the alternator to create more electricity.
• Both systems consist of wiring, harnesses, fuse, relays and modules
Miami Heat Monte Carlo SS.....Linny J
Check out this 88 Monte Carlo SS (Miami Heat Edition) on Asanti A/SF159
24's. Built by 813 Customs in Tampa, FL. With a Full Addictive Audio
System, Asanti Welcome Lights, 383 Small Block, Aerospace Components Disc
Brakes, Halo Headlights, Black Paint with a cherry pearl.