Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

1993 Plymouth Laser DSM 2 1/2 inch striaght pipe w/ HKS muffler

a better sound clip then the other one of my car.


 


More Videos...


Driven
The first Driven DSM Video was filmed in 2002 as a way to explore video production further. This eventually led to Driven 2 and more videos. Included in the Driven DSM videos are the nicest Eclipses, Talons, Lasers and Galant VR4s that the Northwest had to offer with other quick vehicles joining in.





DogBox Racing Laser
1st day at the track, 2nd pass went 9.4 @ 152mph





1993 Plymouth Laser rs
$1500 spent on motor, new valves, timing belt,tensioner,water pump two newer front tires and tie rod ends,and then the tranny went to shit,oh well,now its a dirt track racer in estherville iowa





1992 AWD Plymouth Laser RS Turbo walk around
Just a quick glance at my DSM





DsmClubFinland meet 28.5.2005
First official meeting between few dsmcf members. Video camera didn't like the sun too much, so most of the time too much white..





plymouth laser turbo
fast





Daredevil Driving Stunts in a 1936 Plymouth: "Trial by Torture" 1935 Chrysler Corporation
more at http://cars.quickfound.net/ Toughness of the 1936 Plymouth is demonstrated by showing how components, structures, and the entire vehicle are "torture tested." Includes several good shots of deliberately rolling cars, and daredevil driving by "Hell Drivers' such as Lucky Teter and Jimmy Lynch. Public domain film from the Prelinger Archive, slightly cropped to remove uneven edges, with the aspect ratio corrected, and mild video noise reduction applied. The soundtrack was also processed with volume normalization, noise reduction, clipping reduction, and/or equalization (the resulting sound, though not perfect, is far less noisy than the original). http://creativecommons.org/licenses/by-sa/3.0/ http://en.wikipedia.org/wiki/Plymouth_(automobile) Plymouth was a marque of automobiles based in the United States, produced by the Chrysler Corporation and its successor DaimlerChrysler. Production was discontinued on June 29, 2001 in the United States. The Plymouth automobile was introduced on July 7, 1928. It was Chrysler Corporation's first entry in the low-priced field, which at the time was already dominated by Chevrolet and Ford. Plymouths were actually priced slightly higher than their competition, but offered all standard features such as internal expanding hydraulic brakes that the competition did not provide. Plymouths were originally sold exclusively through Chrysler dealerships. The logo featured a rear view of the ship Mayflower which landed at Plymouth Rock. However, the Plymouth brand name came from Plymouth Binder Twine, chosen by Joe Frazer for its popularity among farmers... The origins of Plymouth can be traced back to the Maxwell automobile. When Walter P. Chrysler took over control of the troubled Maxwell-Chalmers car company in the early 1920s, he inherited the Maxwell as part of the package. After he used the company's facilities to help create and launch the Chrysler car in 1924, he decided to create a lower-priced companion car. So for 1926 the Maxwell was reworked and re-badged as the low-end Chrysler "52" model. In 1928, the "52" was once again redesigned to create the Chrysler-Plymouth Model Q. The "Chrysler" portion of the nameplate was dropped with the introduction of the Plymouth Model U in 1929. Great Depression, 1940s and 1950s While the original purpose of the Plymouth was to serve a lower-end marketing niche, during the Great Depression of the 1930s, the marque helped significantly in ensuring the survival of the Chrysler Corporation in a decade when many other car companies failed. Beginning in 1930, Plymouths were sold by all three Chrysler divisions (Chrysler, DeSoto, and Dodge). Plymouth sales were a bright spot during this dismal automotive period, and by 1931 Plymouth rose to the number three spot among all cars. In 1931 with the Model PA, the company introduced floating power and boasted, "The economy of a four; the smoothness of a six." In 1933 Chrysler decided to catch up with Ford and Chevrolet with respect to engine cylinder count. The 190 cu in version of Chrysler's flathead-6 engine was equipped with a downdraft carburetor and installed in the new 1933 Plymouth PC, introduced on 17 November 1932. However, Chrysler had reduced the PC's wheelbase from 112 in (284.5 cm) to 107 in (271.8 cm), and the car sold poorly. By April 1933, the Dodge division's Model DP chassis, with a 112 in (284.5 cm) wheelbase, was put under the PC body with DP front fenders, hood, and radiator shell. The model designation was advanced to PD and the car was marketed as the "DeLuxe" 1933 Plymouth. This car sold very well and is the 1933 model most commonly found in collections. The PC became the 'Standard Six'. It had been the 'Plymouth Six' at introduction, and was sold through to the end of 1933, but in much lower numbers. It is consequently in the minority in collectors' hands today. In 1937, Plymouth (along with the other Chrysler makes) added safety features such as flat dash boards with recessed controls and the back of the front seat padded for the rear seat occupants. The PC was shipped overseas to Sweden, Denmark, and the UK, as well as Australia. In the UK it was sold as a 'Chrysler Kew', Kew Gardens being the location of the Chrysler factory outside London. The flathead 6 which started with the 1933 Model PC stayed in the Plymouth until the 1959 models. In 1939 Plymouth produced 417,528 vehicles, of which 5,967 were two-door convertible coupes with rumble seats. The 1939 convertible coupe was prominently featured at Chrysler's exhibit at the 1939 New York World's Fair, advertised as the first mass-production convertible with a power folding top. It featured a 201 cu in, 82 hp version of the flathead six engine. For much of its life, Plymouth was one of the top-selling American automobile brands; it together with Chevrolet and Ford were commonly referred to as the "low-priced three" marques in the American market...





93 plymouth laser 0-60
this is a quick 0-60 run in my 1993 plymouth laser RS AWD. it is slightly modified, and yes, it is a slushbox. no, i am not doing a conversion, unless you do it for me.





1992 Plymouth Laser AWD Turbo
The video is for my brother... Here is your babe... ENJOY!!!





My Plymouth Laser rs 0 to 105 pull
This is my 1990 Laser turbo, small 16g, K&N air, Exhaust. rims. let me kno what you think?





Plymouth Laser VS. Mustang 5.0
Plymouth Laser Vs. Mustang





300 Hp Plymouth Laser RS Turbo AWD WOT Pull
1st, 2n and 3rd Gear Pull. Backed off a bit on 3rd gear bc ran out of roads.





DSM Tribute
This is a tribute to the DSM, one of the best bang for bucks in the industry. Make sure to check out my cardomain page to look at my 1993 Talon TSi build progress. http://www.cardomain.com/ride/3223622





DSM - 3" TBE w/Magnaflow Muffler (sound clip)
Sound clip of a 1G DSM with a 3" turbo back Exhaust and a magnaflow muffler.





1959 Plymouth Sport Fury - Test Drive & Review
Since I am into more things than just RC I thought this might be a great way to expand the channel a little. I have been wanting to do a review and drive of a long time member of the family. This is the old man's 1959 Plymouth he has had.. well basically since 1959. I hope you enjoy seeing this "old bomb" as he calls it. Vehicle Highlights: Fury V-800 Super-Pak V8; 318ci - 260hp / 345tq. Torqueflite automatic trans 2.93:1 Axle ratio. 2dr Hard-Top. Non-restored survivor. Music: Provided by Kevin MacLeod (incompetech.com)





Which car is faster? Which Car is Faster?




Similar 1/4 mile timeslips to browse:

1991 Plymouth Laser RS Turbo: 9.612 @ 141.960
kiggly, Turbos: PT74GTS Tires: Slicks


1990 Plymouth Laser RS Turbo: 9.975 @ 141.350
Joe P Bucci, Engine: 4G63, Supercharger: N/A Turbos: 16g Tires: M/T


1992 Plymouth Laser RS AWD: 11.194 @ 126.840
Frankie Bones, Engine: 2.0L 4G63, Turbos: SCM61 Tires: Nitto NT555R 225-50-16


1992 Plymouth Laser RS AWD: 11.940 @ 114.660
Paul, Engine: 2.0 4G63, Turbos: TO4B M-trim Tires: snow tires


1990 Plymouth Laser rs-turbo FWD: 12.220 @ 117.235
jeff k., Engine: 2.0 d.o.h.c. turbo, Turbos: FPG turbo 730cfm Tires: slicks 24.5


1992 Plymouth Laser Rs Turbo FWD: 12.300 @ 119.360
Stanley, Engine: 4G63, Turbos: 16g(evo3) Tires: 215/45/vr17


1992 Plymouth Laser RS AWD: 12.458 @ 108.180
Jerry Ledford II, Engine: 4 cylinder, Supercharger: n/a Turbos: stock 14b


1992 Plymouth Laser RS AWD: 13.362 @ 100.780
Jerry Ledford II, Engine: 2.0 Liter DOHC, Turbos: Stock 14b


1993 Plymouth Laser RS Turbo: 13.731 @ 98.020
Justin Crisswell, Engine: 4G63, Turbos: 14B


1992 Plymouth Laser RS awd: 13.920 @ 0.000
Dennis Davis, Engine: 4g63, Turbos: stock 14b Tires: dooky dunflops


1992 Plymouth Laser RS AWD: 14.077 @ 98.860
Billy Prater, Engine: 4g63T, Turbos: EVO 3 16g


1990 Plymouth Laser RS Turbo: 14.969 @ 93.710
, Engine: 2.0 Liter Turbocharg, Turbos: Stock Mistubishi 14B Tires: BFG Comp T/A's


 


©2015 DragTimes - Disclaimer - Contact Us