BAD BOYZZ GARAGE ATTACKS THE RING ACR-X 7.03
Dodge Motorsports & SRT ran the ACR-X prepped with Bad Boyzz Garage's ACR-X
Clutch Kit & Bad Boyzz Series Headers at the Nurburgring in Germany with a
blistering lap time of 7.03
NARRA - Sunday Race @ Motorsport Park Hastings - August 7th, 2011
This is the Sunday race in-car video from rolling start to checkered flag.
I started on tires which had 2 qualifyings and 1 race already on them and
the tires began to fall off about halfway into the race. I just tried to
hang on and not do anything stupid and not lose the lead. I'm glad the race
didn't go any more laps because the tires were really getting greasy. :)
DC Performance Stage 2 Gen4 Dodge Viper
This Gen4 Dodge Viper was built and tested @ DC Performance in Los
Angeles. Stage 2 Viper includes Belanger headers, DCP Custom Intake
Manifold, Performance PCM, and our Proven Performance Dyno Testing. Call us today for
all your performance product needs! 800.841.8979.
A&C Performance Dodge Viper
Steve B's 2003 Dodge Viper
American Racing Stepped Headers, Corsa Exhaust, K&N Filters
A&C Performance SCT Custom Tune.
Most Vipers with this setup run about 500 rwhp, this is by far the
strongest one we've tested with only bolt ons. Congrats Steve and thanks!
Viper ACR-X racing with David McNiel's full race prep ACR
A day at the track with David McNiel of EMS Racing and the new Dodge Viper
ACR-X.... This was taken at MotorSports Ranch Cresson TX February 2010.
Dodge brought out the ACR-X for testing and display at the Viper Day's
event... I had an opportunity to run with the car in one of the sessions.
Amazing New Dodge Viper ACR-X V-10 Dyno Test
Viper Powertrain Development Engineer Dick Winkles takes us through a Dyno test of the V-10
powerplant under the hood of the Dodge Viper ACR-X race car. The engine
generates more than 600 horsepower. The test was
conducted at the Chrysler Technical Center, Auburn Hills, Michigan.
Custom Intake Manifold Gen4 VIPER Dyno Testing @ DC Performance
This is a 2009 Viper with DC Performance exclusive custom intake manifold.
The results were 24HP at the wheels. If you are looking for more power out
of your Gen 4 Viper then look nowhere else. DC Performance is your
one-stop shop for high performance products. call us @ 800.841.8979.
Heads and Cam Viper
Removing and installing heads on a Dodge Viper SRT-10. Mods included
ported OEM heads by Greg Good, Comp Cam camshaft, T&D roller rockers, ACR-X
Exhaust, throttle body, and cold air
intake. Remote tuning by Todd at A&C Performance via SCT. Just about
everything else in the drivetrain is stock, including stock short block,
fuel system, clutch, damper, etc. Final Dyno numbers are 643whp/604wtq.
Sorry about the music, the royalty free music is very limited.