Ls4 Fiero test drive
Just finishing up my engine swap, doing a little driving up and down my
street checking it out.
572 Cu In Streetable Big Block With 750HP
Live engine run of a Chevy 572 big block...engine will be run in a '66
Chevy Chevelle...Proformance Unlimited...There is no other
Our staff is available to assist you with any questions you may have
Monday-Friday 8am-5pm 800-267-3940 or via email
We look forward to speaking with you.
revival of the LS4
comp vid of rebuild of the entire valve train on a 07 imp SS.
valve train parts are
Thunder Racing 224/224 112LSA cam
Comp Cams hydraulic roller lifters, chromemoly 7.400" puchrods, 918
springs, titanium retainers
Harland sharp 1.7 rockers
Dyno after 6 pulls got
to 278 HP 263 TQ, motor was considered heat soaked at this point IAT's were
at 170+, projected HP is 288-293whp.
How To Connect a LSx Series V8 to older GM 4 Speed Manual Transmission
In this video I show you how to connect your original older 4 speed manual
transmission such as a Borg Warner Super T10 or a Muncie M20/M21/M22 to
your new LS Series engine you might want to swap into your car.
Part Numbers you need:
Sachs - Clutch Kit Part # K5552-03 from O'Reilly's
Note *(10 Spline clutch)
Sachs - Flywheel Part # NFW1050 from O'Reilly's
LS2/LS7 Pilot Bearing Part # : 57080 from O'Reilly's
Grade 8 Metric Bolts for pressure plate
Just starting the engine for the first time outside of car. Getting ready
to put it in an 88 Fiero.
Fiero electric motor transaxle first test
This is a major milestone in my 1986 Pontiac Fiero electric car conversion
project. After numerous delays getting the correct adapting hardware for
the new motor to the old transaxle, we finally mounted the clutch and motor
assembly onto the transaxle and frame of the car. With everything in place,
I applied a regular 12 car battery to the motor and amazingly, it ran
without a hitch! See my website (www.roboticmayhem.com) for more
information on this project.
LS4 Fiero startup
Just a quick video to hear the car start, drive, and power steering effort.
How To: 4 Wire LS Wiring Harness Conversion, Part 3
In part three we finish up the wiring harness, centralize the grounds, and
bundle the wires. To finish the harness, all bundles of wires are wrapped
in split loom for protection and to retain the factory look.
Wiring Harness Pinout: http://lt1swap.com/99-02_vortec_pcm.htm
LS Engine Surprise
Engine: 2005 5.3 ltr 325 hp fuel injected computerized chevy V8
Trans: 2005 computer controlled 4L60E
Front Susp: Mustang II
Rear Susp: 5 link Coil-Over adjustables
Rear End: Ford 8.8 3:73 posi
Power 4-wheel disc brakes
Boxed Frame Gloss Enamel Black
Front Wheels 20X8 Foose Nitro
Rear Wheels 20X10 Foose Nitro
Custom Chrome Headers
Flowmaster 40 Mufflers