THIS RX7 RACE CAR IS NOW FOR SALE,RUNS 400 BHP ON 0.7 BAR OF Boost,490BHP ON 0.95 SO VERY SAFE Boost LEVELS,HAS HALF BRIDGEPORT ON FRESH BUILT ENGINE AND BOX,WATER/METHANOL INJECTION.TEIN COILOVERS,RACING BEAT FULL Exhaust SYSTEM,APEXI MANAGEMENT AND CONTROLLER ,275 / 40 17 INCH ROTAS,HOOSIER SLICKS BEST AVAILABLE,BEST HANDLING CAR AROUND WITH THE POWER TO MATCH.SAFETY DEVICES ROLL CAGE,SEATS FIA,BELTS,FIREATER SYSTEM ETC ETC.CAR IS MOTED AND TAXED ROAD LEGAL
1650 HP RX7, "The Sleeper Part 2", Scary and Funny, from NRE.
Nelson Racing Engines 1650 HP RX7 road video of this crazy sleeper.
Awesome power in this tiny car. This car is really scarry and very fast.
Some very funny video. I laughed a lot. More information and downloadable
videos for your IPOD and PS3 can be found at at
http://nelsonracingengines.com. and http://nelsonsupercars.com.
ZR1 Vette vs Jet! - Chevrolet Corvette ZR1 Races A U.S. Navy Fighter Jet
MT Editor at Large Arthur St. Antoine pits Chevy's awesome "Blue Devil" --
the Corvette ZR1 -- against its toughest adversary yet: a Blue Angels
F/A-18 Hornet fighter jet.
Shot By: Jim Gleason & Terren Lin
Edited By: Jim Gleason
Read the story here:
rx7 kirkistown 470 bhp bridgeport race car
1993 rx7 single turbo,td04z,bridgeported,water methanol
injection,apexi fuel management,racing beat full system,tein flex
coilovers,road tyres in this clip,safety devices full cage,17inch by 9.5
rotas with hoosier full slicks
Mazda Rx7 4-rotor race car. The making of a Defined Autoworks Beast. [Offical Video]
Never before seen footage showing the assembly/start-up of our custom
4-rotor. It is the first 4-rotor since the 787b to use triple spark plugs
per rotor. It is also the first since the 787 to feature telescoping intake
manifold. Custom made slide throttle body system. A world first however is
the use of a center main bearing and 4-piece eccentric shaft. Quick specs-
9.7:1 rotors, lightened and race clearanced. Race main bearings, and race
rotor bearings, ceramic NRS 2mm apex seals. Custom stationary gears, Full
custom Peripheral Port in each rotor housing (defined auto), Aluminum side
housings for reduced weight. Needle roller bearing in the center housing.
4- Piece eccentric shaft 0:47
Dynamic engine balancing 1:23
Variable length intake 2:20
Engine assembly 2:32
Rotor rotation 3:49
Slide throttle 4:00
4-rotor startup and idle 4:30
All footage and editing was done by Defined Autoworks. Music by Ivan
Contact us at 614-592-7991 we build any type of rotary powerplant to the
See the build thread here-