1929 Ford Coupe Hot Rod ~ Running Day 1
So the first day off the trailer we took out the car and it died on us
leaving us stranded. Started troubleshooting with the builder and found
out it wasn't getting spark. Tracing wires we found that the ballast
resistor wire had been pulled out of the spade connector. Simple fix so
we're back up and running. More videos to come.
1960 Peterbilt Hotrod Truck called Piss'd Off Pete
While I was at SEMA 2009 a captured a video of Piss'd Off Pete's engine
being revved up in front of a huge SEMA crowd just down from the
This is Jay Leno's 1960 chopped Peterbilt with a 852ci two-stroke Detroit
Diesel twin-supercharged V12 mated to an Allison 4-speed automatic
transmission from a Greyhound bus. The engine produces 500 horsepower and nearly 1000
lb-ft torque with a red line of just 2,800 rpm. Built by the Blastolene
See more pictures at www.autogeekonline.net
V16 HOT ROD (Twin V8) doing a burnout, part 2
Different angle and inside view of the twin V8 car, the tires are Nitto
NTO5 Drag slicks 315/35/20
Note: The road is at a 10 degree angle and is 2300 lbs with 1000 hp hence
the brake is on to keep it straight also the car does not have a traction
problem, this is an exhibition burnout! It will launch very hard!
Twin Sbc chevy engines just over 900 rwhp 2307lbs 0-60 under 3 sec, mid
9's 1/4 mile gear limited for 180mph
(This car was built for shits and giggles and is not yet finished)
more vids here http://www.youtube.com/user/SireCustoms?feature=CAQQwRs%3D
check out our facebook
Dodge Challenger Slow motion Wheelie
1974 Dodge Challenger Slomo Wheelie vid. Santa Pod 2010 eurofinals. By
Blackett Photography. Here the car is powered by a 572ci Wedge motor. Runs
mid 9's @ full weight (3850lb +). To make the caltracks work you need
plenty of front end lift, bump stops were removed and frames notched to get
almost 6 1/2 inches of travel. Something Chrysler never designed that
suspension for I'd guess. We've since improved the bump steer by replacing
parts and resetting the camber / castor as the front has aftermarket parts
and plenty of adjustment.
In reality it's difficut to fully eliminate without going to a strut type
front end, though some people appear to have done it on stock stuff, it
seems to be a common chrysler trait. Check out the superstock video's from
the '70s and most Mopars do it also check out my other real time wheelie
vids you see that the wobble lasts only a fraction of a second.
Thanks for the comments.
The Shark (Rat Rod)
Interesting things found at small, local car shows. This project was found
in southern New Mexico. The song is Rat Rod by Terry Davidson and the
Gears from the album Damnation Blues. Available for download from Amazon.
RAT RODS HOT RODS AUTO ART JUNK YARD RUST RATFINK ED ROTH GEORGE BARRIS
worlds fastest fiat 500
Tag Racecraft.com Built 1970 Fiat 500 with stock body 10.44 E.T. at 138.9
mph. sponsored by Bully Performance Clutch.
GSXR Powered VW Bug HotRod
Check out this crazy creation from the minds of Hudlow Axle in Georgia.
They made a Hot Rod VW Bug with a GSXR 1000 Motor! This thing rips. It uses
air bag suspension, custom 2wd cherokee front axle, sidekick rear axle, and
much more. Be sure to Like our Facebook Page at