Valeo Filter za gorivo - oprema filtera za gorivo- in line type
"Valeo Filtracija motora - Filter za gorivo
In line tip
Dugotrajnost & preciznost
Sa Valeo, zamena vašeg in-line filtera za gorivo je jednostavna
Za benzinske motore kodovi od 587 000 do 587 199
Za dizel motore kodovi od 587 500 do 587 699
Valeo preporuluje zamenu foltera za gorivo na svakih 30 000km ili svake dve godine za vreme servisiranja vašeg vozila
Valeo, automotiv tehnologija, prirodna.
• Sledi Valeo on facebook: http://www.facebook.com/Valeo.Group"
2009 VW Jetta TDI - Fuel Filter Change
Fuel Filter Replacement in a nutshell:
1) Replace every 20K miles (I do mine every 10K with oil change).
2) Have the right filter for your housing.
3) Engine OFF! Remove Upper Sound Absorber Panel.
4) Water Separator Service (1 Screw Plug, 1 Washer Seal)
a. Remove Screw Plug and old Washer Seal with Torx T30 bit.
b. Siphon water at bottom of Filter Housing from top of housing - A.K.A
c. Siphon enough fuel to avoid spillage when Housing is opened.
d. Reinstall Screw Plug with New Washer Seal. Torque 3 Nm (27 in-lb).
5) Fuel Filter Replacement (1 Filter, 2 Seals on Filter, 2 Seals in
a. Remove 5 Torx T30 Bolts and lift off Upper Filter Housing with lines
b. If you see any amount of metal particles TAKE THE CAR TO A
PROFESSIONAL! You have a major issue.
c. Pull out old Filter and Seals in Housing.
d. Clean as necessary Lower Filter Housing by Siphoning out remaining
NOTE: Removal of Lower Filter Housing is not a requirement. So long
as you remove any contaminants found at the bottom of the canister by other
e. Install New Filter and New Seals.
f. FILL CANISTER WITH CLEAN FUEL to help purge air. (approx. 650 ml or
22 oz) ---OR--- Use VAG-COM to operate fuel pump from fuel tank to prime
the fuel system (the air will be sent back to the tank to vent) SEE VAG-COM
STEP BELOW (7).
g. Reinstall Upper Filter Housing and secure with 5 Bolts. Torque 5 Nm
6) Reinstall Upper Sound Absorber Panel.
7) If you have VCDS/VAG-COM, operate fuel pumps to purge air from Filter
8) Otherwise, Start Engine & try to run it at 2K RPM for at least 30
seconds. If Engine shuts down, restart engine (this method is not
preferred. it is bad for your High Pressure Fuel Pump).
NOTE: Turning key to turn on Accessories does not turn on the fuel pumps,
from what I have read, only when the key is turned to Ignition (Engine
A visual aid to what to expect when replacing the Fuel Filter on the 2009
VW Jetta TDI (A5 - CBEA ).
I used as a reference the Bentley Publishers VW Jetta Service Manual
(2005-2010) as well as a couple of very good write-ups which can be found
at the following links. Many thanks to those who took the time to document
and share the information at these links.
I obtained the Mann Fuel Filter from IDPARTS.COM (formerly TDIPARTS.COM),
UPS Ground Shipping was free with them. Amazon.com also offers the same
Mann Fuel Filter for those who are exclusive to Amazon.
Fuel filter change step by step
How to replace/change a fuel filter step by step on Renault Megane/Scenic
Next part here (circuit priming) :
with a primer bulb : http://youtu.be/2ZU-r1jb4a8
without a primer bulb : http://youtu.be/_kWS4ueRovY
Auto car vehicle maintenance tools parts accessories engine mechanics
do-it-yourself diy tutorial tuto
This video does not constitute or replace a real specialized technical
manual, and was only made for convenience and educational purposes.
"Tuto4BuildEng" makes no warranties of any kind and accepts no liability.
"Tuto4BuildEng" cannot be held responsible for any damage caused to devices
or persons using information contained in this video.
The use of the information contained in this video is at your own risk.
406 HDi 110 Engine Maintanence
The 406's annual service. A number of things are done. The oil gets
changed, a new oil filter put on, new diesel filter, air filter changed and
egr cleaner sprayed in. As well as a new pollen filter to get rid of the
stale smell coming from the air vents.
This is the first time I've used ramps to change the oil, they did need
some wooden blocks to raise the car up before driving onto them but it
makes working under the car and holding the camcorder much easier.
I didnt have an oil filter wrench to hand but using the screwdriver to turn
the filter doesn't do the car any harm the old filter is going to the bin
Renault Clio 1.2 16v D4F Throttle Body Removal
The clio was running strange recently cutting out at junctions, not idling
right and on the open road not driving very smoothly. Also sometimes it
failed to start which was caused by oil coming out from the air filter
housing and dripping onto the crankshaft position sensor.
I did this to remove the throttle body and clean it out, also the
crankshaft breather pipe is located in here. In the video i didnt actually
clean these parts as i did that last week but they were covered in oil and
crap, the crankshaft breather had a lot of old sludge which i had to scrape
out but its very clean now. The throttle body took a bit of time with some
carb cleaner but as you see in the video thats how clean it needs to be.
It has made a huge difference to the car, there is no more lights on the
dash, it has been running very smoothly and on the open road there is no
cutting out or spluttering when planting the throttle.