My 2000 Honda accord Intake sound Test revved outside and on inside.
PS-Honestly, the suction isn't that loud, the camera is a little sensitive lol
Mods so far:
*Temporary* Spectre SRI
Motegi R7s (215/16/45)
2000 Honda Accord F23A
Short Clip of my 2000 honda accord F23a Coupe. Cold air Intake and Full Exhaust with a Stock muffler. ( I know
its slowing down my flow) i dont calim this to be the fastest car, its no
where near that. just figured with all the v6 coupe videos id throw one out
with a 4cylinder. This is just the beginning for this car. thanks
Bikers 80 - Kawasaki Burnout, Suzuki, Honda, BMW Wheelie, Yamaha Ducati & More Superbikes
Subscribe to our channel for more videos!
Like BikersBR on Facebook - facebook.com/bikersbr
Bikers HD 80 - On the video:
BMW S1000RR HP4
Ducati 1199 Panigale S
Honda CB 600F Hornet
Honda CBR 600RR
Honda CBR 1000RR
Kawasaki Ninja ZX6R
Kawasaki Ninja ZX10R
Suzuki Bandit 650
Suzuki Bandit 1250
Suzuki GSXR 750
Suzuki GSXR 1000
Suzukii GSXR 1300R Hayabusa
Video Compilation edited by Ed Cunha - Filmed by EdCunha
Camera: Canon SX40 HS, Rebel T4i and GoPro Hero 3 Black Edition - Filmed in
1080p Full HD
Curitiba, Paraná, Brasil
How To Pull Honda Codes Without a Scanner -EricTheCarGuy
Link to code explanations:
Honda ABS Codes 1994-1997:
Honda ABS Codes 1998 and up:
Visit me at: http://www.ericthecarguy.com/
Discussion about this Video:
I feel like I should have made this video a while ago but the opportunity
never came up. Since I had this RL in my shop that had a check engine
light AND an ABS light I thought it was a perfect opportunity to put this
video together. I get asked all the time about my 'special tool' and it's
really nothing more than a Honda 2 pin connector with the input wires
soldered together. These connectors might be harder to find than you think
but if you run across a junk honda and one of these is on the harness grab
it. Even if you don't have the tool a paper clip or piece of wire will do
the exact same thing so don't sweat it if you don't have the tool because
shorting the connector is all you need to do.
I hope you find this video helpful.
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
Honda Accord VS Lamborghini Murcielago. EXOTIC CARs RACING, TOUGE FUN!!
found a pack of Exotic cars meeting up, so i sayed.. hmmm this could be
so i joined in with my little Gas Saving Honda to race these high end
Performance Cars!! XD
good racing and fun! too bad there was so many cars that the racing was
very limited.. =/
and if you may ask about my car, its;
naturally aspirated (all motor) Frankenstein H/F series putting out 234whp
built by myself (", )
end of the video: the whole pack of cars cruising by.
Honda Accord AEM V2 Cold Air Intake Installation
2002 HONDA ACCORD SPECIAL EDITION
2.3L, 4 Cylinder v-tec
Series F23A1 Engine
I'm no professional at this. I'm still very new and learning more about the
import tuner world.
I've never done an intake installation before and this one is my first.
Please don't over judge me too harshly.
The video was more for me on how to install it, but I thought I would share
this with everyone.
Enjoy the video!
Cold Air Intake Install (01' Accord Lx)
This is a Cold Air Intake I bought from Ebay and installed on my car. I
hope to have video of the new sound from the engine which the intake gave
an aggressive sound to. Looks like a professional intake but I did have to
modify the intake tubbing. Install called for me to place the filter in the
fender well which I did not do because I could of sucked in water and
caused my engine to Hydrolock and bend and blow pistons. So I installed it
where the old factory air box was placed. Hope you like it and it helps you
with an install.
Car Sounds With Mouth 2 (68 Camaro, M5 Turbo, Honda Civic, and more!)
Sick McVick is back with a huge array of car sounds to show the world!
Please like,comment and share!
Like Sick McVick on Facebook-
Check out part 1 here- http://www.youtube.com/watch?v=8WdMtvlmwA8
Video recorded with a Panasonic ag-hvx200
Audio recorded with a Sennheiser ME 66 shotgun mic
Light was provided by a Kino Flo Diva-Lite 200 Kit
Honda F6B : la moto qui arrache les molaires
Qui a dit que les bikers en Harley avaient une dent contre les Japonaises ?
Sûrement pas notre cobaye Jean-Eudes, alias Chicco, qui s'est rendu à la
concentration de Morzine au guidon de son nouveau bagger F6B, réalisé par
Honda sur la base de la fameuse GoldWing, pour se faire des amis au sein de
cette population ouverte...
Honda Accord VTEC timing belt and water pump Honda Accord VTEC High Detail How to
You can buy a quality belt and water pump online here
Special thanks to Spanky for filming this video for me. : ) My last
Honda Accord video was
very well viewed, but lacking in good sound, stability, and lighting so I
did another one with some help. Enjoy High Detail How to do a timing belt
and water pump Honda Accord VTEC