How To Replace An Engine

scotty kilmer, mechanic for the last 46 years, shows how you can replace an engine in your vehicle. And, If you like my car help, be sure to watch my live car talk show every Saturday morning at 10 AM CST on YouTube. I answer your car questions LIVE there. Just check it out at https://www.youtube.com/watch?v=VognjkYaMjg&list=UUuxpxCCevIlF-k-K5YU8XPA&feature=c4-overview . And remember, every TUESDAY I upload a new video, so don't miss them. -~-~~-~~~-~~-~- Please watch: "Fixing Your Car with a Laser" https://www.youtube.com/watch?v=dI0bz8klFmI -~-~~-~~~-~~-~-

More Videos...


How to Remove an Engine
Here's how to disassemble and remove an engine and transmission from a Toyota Corolla. Removing the engine from most transversely mounted, 4 cylinder cars are quite similar. In my case, I opted to disassemble major components off of the engine before removing the engine and transmission as an assembly, including water pump, alternator, starter, AC compressor, power steering pump, air intake, throttle body, radiator, AC condenser and Exhaust manifold. This allows a lot more room in the engine bay for removal. if your doing a straight engine swap, the removal of these components is not necessary. Once the above mentioned components are removed, there are 4 engine mounts that hold the engine/tranny to the car body. The front and rear mounts are bushings with a thru bolt. They are secured underneath the subframe by 3-4 bolts. The driver side tranny mount is also a thru bolt. However since the tranny is being lifted up, the mount must be removed from the inner fender. The passenger side engine mount is a vertically mounted bushing, and is typically left for last. Strapping the engine was done with a thick heavy chain, around the engine. Seat belts were used across the driver and passenger side mounts for balance. A shop crane was used to hoist the engine and transmission up over the car, and then the car was rolled back. 6 bolts hold the engine to the transmission at the bell housing. Once separated, the torque converter is exposed. It can then be unbolted from the flywheel beneath the access plate under the engine block. The flywheel is then unbolted, and the engine mounted to an engine stand using the engine mount bolts. This process was demonstrated on a 2001 Toyota Corolla with a 1ZZ-FE vvti engine.





How to SUPER CLEAN your Engine Bay
Engine bay detailing. Learn how to Super Clean your engine bay so that it is so clean, you can eat off of it! I show you how to clean and detail the engine bay in a simple 5 step process that will NOT damage your engine or electrics! Cleaning Wipes (Tub-O-Towels): http://amzn.to/2u7CgAD Soapy Wooder: https://goo.gl/hsebW4 Microfiber Towels: http://amzn.to/2sKi2cR Brushes: http://amzn.to/2sKgwau Trim Restorer: http://amzn.to/2sJLmjP Spray Wax: http://amzn.to/2sZ96og Pipe Cleaners: http://amzn.to/2sJzA8R Fabric Dye: http://amzn.to/2v62qks Metal Wire Brush: http://amzn.to/2u2VPL7 Rotary Tool: http://amzn.to/2v6lVcI Paint Markers: http://amzn.to/2ucPEUW How to SuperClean your Car: https://youtu.be/CFXfSBR5Q9w?list=PLvKbarVtwhUs7sIm9Hc9VgANltYl8_DwC How to SuperClean your Windshield: https://youtu.be/vJkfrY2owb0?list=PLvKbarVtwhUs7sIm9Hc9VgANltYl8_DwC How to SuperFlush your Cooling System: https://youtu.be/s--5ft5YiHg?list=PLDD611CFB36FC65F2 → Become a ChrisFix Subscriber: http://www.youtube.com/subscription_center?add_user=paintballoo7 → Instagram: https://www.instagram.com/chrisfixit → Facebook: https://www.facebook.com/chrisfix8 → Website: http://www.ChrisFixed.com → My Channel Home Page: https://www.youtube.com/ChrisFix **If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Week** Disclaimer: Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix. This video was supported by Federal Process Corporation and all opinions are truthfully my own. I use their stuff all of the time when cleaning my engine bays which made it a great fit for the video!





Why Mechanics Charge So Much
Auto mechanic for the last 49 years, Scotty Kilmer, shows why mechanics often charge so much when fixing modern cars. A whole lot has to do with the over use of computer control systems on cars. Auto Repair, episode 3, summer 2017. If you liked this video give it a Thumbs Up and consider subscribing. And remember, every TUESDAY I upload a new video on the Scotty Kilmer Channel on YouTube, https://www.youtube.com/user/scottykilmer Also, if you like my car help, be sure to watch my live car talk show every Thursday afternoon at 1 CST and Saturday morning at 10 AM CST on YouTube. I answer your car questions LIVE there. Just check it out at: https://www.youtube.com/watch?v=yQtdBelbqdg -~-~~-~~~-~~-~- Please watch: "Fixing Your Car with a Laser" https://www.youtube.com/watch?v=dI0bz8klFmI -~-~~-~~~-~~-~-





TOP 10 Homemade ENGINES
Sources & Credits: 10. Smallest Handmade Engine https://www.youtube.com/watch?v=UyPd40uNVUQ 9. 8 Cylinder Engine https://www.youtube.com/watch?v=XsD8aI6nPV0 8. Victory 44 https://www.youtube.com/watch?v=B9zt3SF_Flc 7. W-32 https://www.youtube.com/watch?v=ZVuKp5M3de8 6. V12 Solenoid Motor https://www.youtube.com/watch?v=6HND4x22jXM 5. 7 Cylinder Radial Engine https://www.youtube.com/watch?v=SyRJeZ6s8uM 4. Straight Eight https://www.youtube.com/watch?v=p5y3a2did4E 3. V10 Model https://www.youtube.com/watch?v=RUv1hv7g7WA 2. Flying Millyard https://www.youtube.com/watch?v=ND4EA0dnAM8 1. Sutton's Radial https://www.youtube.com/watch?v=7WAtEvkAQs4 Music: "Escape From Area 51" By K1Woods Licence purchased from premiumbeat.com Please contact me at messagejdrock@gmail.com if there is any dispute about content being used in this video or if you want a video clip removed, thanks!




Follow