engine shampoo gone wrong

http://www.youtube.com/maceyofgrandbend hillbilly trying to make a buck

More Videos...

Must See! Gasket blows up in Integra and the kid decides to change it on the spot!
Auto show in Erie, PA, looks like he changed a few of those in his lifetime lol. Feel free to like my facebook page to see the photos behind the videos. http://www.facebook.com/antonbachukphotography

How NOT to remove your engine.
Subscribe to my channel, I'm always posting great videos! About this video, I know this is a bad idea. There were some idiots on the turboDodge.com forums suggesting that this was a good idea. I needed to get a blown motor out of my car, so I setup the camera and demonstrated exactly what can go wrong with this method. Honestly, I tried to get it down gracefully, in the end I guess I was lucky it didn't knock the car over in the process. Let this be a lesson to all, use an engine crane. At least in cars where it's not designed to come out the bottom.

1936 Fairbanks Morse Model 32D
Running in Pottsville Oregon. Hard to tell from a video but this thing shakes the Ground when it runs.

DIY: Engine Bay Washing
Video tutorial on how to wash dirt, grease, or grim away from your engine bay. Make sure your engine is cool when you do this procedure. Spray the solution onto the engine and around the engine bay, let it soak for approximately 5 minutes, then continue to rinse off with hose or pressure washer. Let engine dry for a few hours to prevent the vehicle from running rough. This particular video was done on a 2000 Subaru Outback 4 cylinder wagon. The soap I used in this video is called Spray Nine, but I'm sure there is other cleaners available which will do the same job. Areas to take caution around when washing: -alternator -coils/distributor -spark plugs -spark plug wires -fuse panel -oil filling places (engine oil, transmission oil, power steering) -brake fluid reservoir -intake -air filter To protect any areas you are worried about water entering, you can cover it up with a plastic bag. Procedure: -making sure your engine is cool, open the hood and spray the engine down with the Spray Nine cleaner -let it soak for 3-5 minutes -using a pressure washer, wash the soap, dirt, grease, grim off the engine being careful about the areas I cautioned about above -if there is still some dirt remaining, you can respray the area with soap and pressure wash it again -harder areas you can scrub down with a brush -leaving the hood open, let the engine bay air dry -using compressed air or a wet/dry shop-vac, you can speed up the drying process Thank you to all those who watch my videos and support my content. Don't forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week! Please LIKE my Facebook page @ http://www.facebook.com/pages/4Diyers/106898752724865 or FOLLOW me on Twitter @ https://twitter.com/4DIYers © 4DIYers 2013 All Rights Reserved No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.