High Centered and Stuck in the Mud
After unloading a load of tree limbs, me and dad decided to drive out to
the back pasture to see how wet it really was. Apparently, it's wet enough
to high-center my F250 on 35" tires.
Trying to navigate out of the mud my front axle plowed into a rut, hanging
the front tires in the water. Trying to reverse burried the rear axle.
Dad's 2500HD on All-Terrain tires can't get the job done.
8.1 liter 496 big block 2500hd
Just a video of my 2500hd with the 8.1 liter allison 5 speed transmission.
pcm4less custom tune k@n cold air intake, magnaflow true dual Exhaust, chipped. Dyno 485 which is pulling power
for this truck. this truck is not set up to race but i have ran a duramax
diesal and ate him for dinner lol. the whining you hear is not the motor
about to blow up its a tensioner pulley going bad.
0-60 run in 8.1L 03 silverado
This is my dad's 2003 chevy silverado 2500HD quad cab. It's got an 8.1
liter, 496 ci vortec with an allison 5 speed tranny. It's not the fastest
truck out there, but it moves pretty good for it's massive size and weight.
BRAND NEW CHEVY BEATDOWN!
DVDs & SWAG - http://www.4x4swag.com
This guy saw the buggies hill climbing and said hell his Chevy Truck could
do that too!
Follow us on Facebook- http://www.facebook.com/bustedknucklefilms
3/4 Ton Trucks in the Mud
Celebrating the 4th of July, we take a couple of heavy trucks in the mud.
The white Chevy is a 03 with 6.0L gas, 6" ProComp lift, and 35" BFG A/Ts.
The grey Ford is an 09 with the 5.4L gas, 2.5" ICON lift, and 35" MT/Rs.
the 2500 holdin it to it in South Carolina
I went through is a few times but after I tore it up I slipped off into a
rut. Those 37's disappeared haha. 6 inch tough country lift, fab four
bumbers, air mass sensor, throttle body spacer, K&N cold air intake, bully
dog triple dog gt programmer