Clutch Master and Slave Cylinder Install on 1998 Saturn SL2
First I want to apologize for the amount of movement you will be seeing in
this video. items I was replacing could not be seen very well if I was
using a tripod. so It was done by hand.
In any case, This is a video I made for the removal and install of the
clutch master cylinder and slave cylinder on my 1998 Saturn SL2. I have
been wanting to do this for a while because every time I pressed down on
the clutch pedal it would sound like finger nails on a chalkboard. It was
time to replace it and what a good opportunity to learn how to do yet
another bit of maintenance on my car myself instead of bringing it to a
mechanic. I went to my favorite site for Saturn maintenance and found the
Thank you ShawnV at SaturnFans for the excellent picture tutorial.
I figured I would try to do something different and make a video since that
was something I was looking for as well. Hope this helps.
Who races a saturn 4 door car?
My 1997 saturn SL1 converted. I took out the sohc and put in a dohc,
header, 2 & 1/2" Exhaust with Dynomax muffler. High voltage
MSD coils, 8.8 wires. It had a bored throttle body and true cold air
intake. I installed an egr block off plate and I used fuel injectors from a
Pontiac grand am gt. The transmission is the original 5 speed from the sohc
setup which has lower gearing. The car was dropped a little by cutting the
strut springs. The wheels are 16" aluminum. The guages were changed as well
with the motor swap as can be seen at 4:57 in the vid, so the readings are
accurate. Note how it pulls from 60 to 90mph. Pretty decent for a naturally
aspirated 4 cylinder.
2001 saturn sl2 intake manifold removal part 1
2001 saturn sl2 intake manifold removal " I DID NOT REMOVE the hose from
the bottom of the intake manifold til i got the manifold off after all.
ALSO check out the book I wrote for Gentlemen who desire more in life.