How To Install A Monroe Quick-Strut Assembly 2002 Dodge Neon
This is an installation of a Monroe® Quick-Strut® assembly on a 2002 Dodge Neon. This particular installation was completed in less than 5 minutes. No need to take apart the existing strut assembly. No need to compress the coil springs. No specialized tools needed. The Quick-Strut unit comes complete and ready to install.
FRENCH-How to Install a Monroe Quick-Strut Assembly 2002 Dodge Neon-French Version:
http://www.youtube.com/watch?v=vd626Rs_Tsw
For more info, www.monroe.com
Strut bearing replacement
Just bought a spring compressor to do this job.
only special tool necessary here and pretty much the same method on all vehicles.
The diagnosis of bad strut bearings can be done trough several symptoms observation :
-while getting out of a curve difficulty for the steering to come back centered alone
-difficulties to turn the steering wheel while parked
-once all front end lifted, difficulty to turn manually the wheels both directions
-noises from the hood sides compartment while cruising or running on a bump
How To Find Suspension Noises 101 - EricTheCarGuy
How To Find Suspension Noises 101 - EricTheCarGuy
http://www.ericthecarguy.com/
This is probably one of the most popular questions that I get so I'm happy to bring you this one because I know it's going to save me some typing. I may have missed a couple of things but I believe I've covered the basics on this one so this video should give you more than enough to start with.
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
How To Replace a Front Wheel Drive Axle - EricTheCarGuy
How To Replace a Front Wheel Drive Axle - EricTheCarGuy
http://www.ericthecarguy.com/
There were a lot of requests for this and I finally found the opportunity to shoot this video so here it is, enjoy.
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
Monroe Quick Strut Review
http://www.tire-review-expert.com/monroe-quick-strut-review/ Super easy install. These fully assembled struts are ready to install straight out of the box. Toyota Camry, Dodge Caravan, Ford Explorer and many others are prime candidates for complete strut assembly's.
Replacing Honda Front Struts - EricTheCarGuy
Replacing Honda Front Struts - EricTheCarGuy
After posting the last video on replacing struts I thought I would post this one next. I shot this along with the rest of the Accord front end work that I did last fall. A couple of things are different, the most obvious is that the springs are a much smaller diameter so you really need to be careful when you work with these since the spring compressor doesn't have as much to grab hold of. Second, when you install the struts back on the car care must be taken to get the notch on the strut lined up with the wishbone, if you don't do this the upper wishbone bolt will not go in since it has to fit in a groove on the back of the strut.
For the second time I've shown you that I tighten the lower wishbone bolt with the car off of the ground, the fact is I shouldn't do this since I'm told it may ruin the bushing that goes through the lower control arm. I believe this to be possible but I have not experienced any problems doing it this way. For me it just seems like a pain in the butt to try and reach around the tire after I've put the wheel back on. But for those of you that like to point out my faults here is my excuse for not doing it the "right" way.
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Be safe and stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
Rear Strut Removal And Installation
Tools needed proper fitting sockets and wrenches, Special Tool: Spring Compressor. This Im sure is not the best way to go about it, but it works if you don't have the proper tools like a bench and Vice (would have been nice). This is TRUE back yard mechanicin at its most down, dirty, and a lil ignorant.
I don't know why this shakes so much, it did not do this before I encoded it.. Sorry. GOOD LUCK!
VW, Volkswagen Jetta Front Strut Installation 1999, 2000, 2001, 2002, 2003, 2004, 2005
Buy these struts at http://apxautoparts.com/apx/1999-2004-volkswagen-jetta-iv-shocks-struts-full-set.html
Step-by-step instructional video that takes you through the entire process of changing front struts on a 1999, 2000, 2001, 2002, 2003, 2004 and 2005 Volkswagen Jetta. We installed SENSEN front struts from APXautoparts.com. Installation was performed by Mike Moore at Atlantic Car Care in Wilmington, NC. Visit Mike's site at www.atlanticcarcare.com.
Always have your auto parts installed by an ASE Certified Technician. The material in this video is for general information purposes only. You should not rely upon this video to make any installation decisions on your vehicle. Under no circumstances shall APXautoparts.com or our parent company be liable to you or any other third parties for any loss or damage
to yourself or your vehicle.
Which is the best shock or strut for my vehicle?
With so many options to choose from, how do you know which shock or strut is the right choice for you? In this video the Gabriel® Answerman will introduce you to some of the most popular Gabriel shocks and struts and help you understand how to select the one that best meets your needs.
How To Replace Front Struts, 1999 Pontiac Grand Am (Full) - EricTheCarGuy
How To Replace Front Struts, 1999 Pontiac Grand Am (Full) - EricTheCarGuy
http://www.ericthecarguy.com/
Well here is the full length version of this video posted without interruption, I hope this makes it easier to watch and that you are able to get all you can from it as a result. Enjoy.
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.