Dodge Challenger Slow motion Wheelie
1974 Dodge Challenger Slomo Wheelie vid. Santa Pod 2010 eurofinals. By
Blackett Photography. Here the car is powered by a 572ci Wedge motor. Runs
mid 9's @ full weight (3850lb +). To make the caltracks work you need
plenty of front end lift, bump stops were removed and frames notched to get
almost 6 1/2 inches of travel. Something Chrysler never designed that
suspension for I'd guess. We've since improved the bump steer by replacing
parts and resetting the camber / castor as the front has aftermarket parts
and plenty of adjustment.
In reality it's difficut to fully eliminate without going to a strut type
front end, though some people appear to have done it on stock stuff, it
seems to be a common chrysler trait. Check out the superstock video's from
the '70s and most Mopars do it also check out my other real time wheelie
vids you see that the wobble lasts only a fraction of a second.
Thanks for the comments.
Vegas Hustler Wheel Stand
Mark Bishop hooks his Super Pro ET Dragster up a treat as he leaves the
line during Sunday evening at the 2009 Easter Thunderball at Santa Pod
Raceway UK. Mark normally has about 2 inches of wheels up when he runs so
this was a massive shock and caught him off guard. With a 60 ft time of
approximately one second there isn't much time to react. Chassis, steering
and wheels were damaged in the incident and Mark vows to be out again as
soon as funds allow. Ian Blackett
http://www.blackettphotography.com Santa Pod's Resident RWYB Photographer.
(Shot at 300 frames per second and slowed down to achieve this effect).
Mark was back out in action at the Eurpoean Finals.
The Ultimate Small Block Stroker Engine Build -- Part 1
Part 2 in this series is here: https://www.youtube.com/watch?v=q_Bu8sEeNFg
The first video in a series building a big inch stroker motor. We're
cramming 427 cubic inches into a small block Chevy with all off-the-shelf
For the rest of the videos in the series, build sheets and even Dyno results, check out
ltimate-stroker/ . Thanks
We're constantly uploading great new videos. Please subscribe so you won't
MORE INTERNET GOODNESS:
Pro Street Shootout APSA
Both Pro Street Blown and Un-Blown classes qualifying at the APSA FUCHS
Shootout held at Calder Park Raceway.
How To Build a Chevy 383 Stroker - Part 1: Block & Crank
This is a new multi part series on how to assemble a small block Chevy 383
stroker motor (actually it is an internal combustion engine - "motors" are
electric - but I digress LOL).
MOST of the assembly applies to any small block engine. I have divided up
the assembly procedure into many parts so you can skip to the specific part
you are looking for, i.e: crank, camshaft, timing chain or how to adjust
This whole series was shot by myself with my iPhone so presenting, filming
and assembling could all be done smoother but "ir-regardless" I hope it
PS - For those of you who who did NOT get the joke and are taking the
"engine" and "motor" thing WAYYY too seriously, here are a couple
instructional aides to help you figure out why you have no sense of
humor.... also I would never use "ir-regardless" in proper English.
Thank you. Shannon http://www.corvettesandcustoms.org
Chevrolet Vega con motor Ford
Le apodan "El Mestizo" por la combinación, con cabezas rebajadas, pistones
11.5, árbol de levas Crower solidó, araña Edelbrock Victor Jr,
carburador Holley de 750 doble bomba, bobina y cerebro MSD 6AL, Headers
largos, transmisión C4 con Trans-Go.