CRX of DEATH!
Disclaimer: This is not my car
the car belongs to my good friend's father. It is a 88 Crx SI. B20/Vtec
The car used to have an Lsvtec setup which the Dyno video is posted in my
video. best time is 12.6@ 109 mph
********attention new times 12.2 @ 111*****
Team 1320 382whp All Motor K26 Eg Getting Ready For 2011 IDRC West Coast Nationals
Idle and walking around of Team 1320's All Motor Street Car. Getting her
readyy to race IDRC at Fontana auto club aka funtucky April 23rd. 67mm
kinsler ITB w/ eight injector set up. primary's run at idle and low RPM and
secondary top feed injection transition on at high RPM for better
atomization. Custom GO-Powermotorsport / Webcam single lobe vtec killer
camshafts, machined factory roller rockers, skunk2 valve train, GO-Pwr 2.6L
106.xxmm crankshaft k24stroker kit, 90mm arias aluminum 15:5:1 compression
ratio pistons. k24 GRP aluminum rods, aebs sleeves, port flow head, aem
ems, race pack data log and display dash, rywire milspec wiring harness,
fuel lab fuel system with x8 ID injectors, meziere external water pump,
Clutchmasters FX725 twin disc clutch and flywheel kit, Quaife LSD
differential, 4.7fd, 1-4 PAR dog box transmission. GO-Pwr hood exit header,
Q16 race gas skunk2 suspension and camber kit. hasport mounts, 8.50 et's
and slower roll cage done by GO-PWRmotorsports.
how to turbo your honda over the weekend
UPDATE: for all those who think this method means the motor wont last, here
is a video from friday april 5th 2013 of the car still running strong, its
been over a year and around 10k miles of hard beating.
UPDATE: ALSO CHECK OUT MY SECOND VIDEO ON HOW TO turbo YOUR HONDA you can see it here
this video shows the steps to turbo your
honda in a couple days with upgraded internals and not removing the engine
or doing any machine work.
also for those saying you need to do some sort of easy break in period i
think you need to read this article , the old fashioned ways are long gone