Dad's Chevy Big Block 402
Street/Strip Chevy Big Block 396. Full Roller. Hydraulic Big Mutha Thumpr
Comp Cam. 9.5 Compression. Balanced and Blueprinted. horsepower: PLENTY!!!!!
This baby rat will run with most street big rats.
1990 - Part 5 Best of Famoso Raceway Vintage AA Gassers Willys Nostalgia Drag Racing Bakersfield, CA
Drag Strip Riot Posters! http://www.maziracing.com/2004poster/
1990 Vintage AA Gassers Willys Nostalgia Drag Racing, Part 5 Best of Famoso
Race Drag Racing; Dan Horan Jr. Top Fuel dragster, Willys Gassers, K.S.
Pittman, Stone-Woods & Cook, Gary Fore Willys Foreplay Gasser, Junior Fuel,
Vintage Famoso Raceway, Nostalgia Drag Racing, Pro Mods, A/Gas, Nitro Top
Fuel Dragster, Funny Cars, Crash, Funny Car body explosion, Auto Club
Famoso Raceway, Bakersfield, California. Brought to you by
Video courtesy of Ralph West of One Man Video.
383, 388 stroker chevy with comp cams big mutha thumpr
This is a 388 chevrolet engine cold start up. It has a big mutha thumper
cam and 492 dumble hump heads. Heads have been angle milled and bowl
ported with light porting. flat top pistons and block been decked giving
aprox 11.7:1 static compression. 750 edelbrock carb and a dual plane high
rise air gap intake. This is all in a 1960 Chevy truck frame that im
restoring right now. Engine is backed with turbo 350 and ford 9 inch.
Brent Harris 33 Willies Gasser at 2007 Thunder
Brent Harris in his 33 Willies Gasser at 2007 Port Alberni Thunder In The
Valley. A couple burnouts and clips from both Saturday and Sunday. Duane
Grosart's 55 Chev is a beauty too. The 55 wasn't running great as these two
rivals, who are best friends, have at it.
Again, thanks to Carl Sexsmith and Phil Anker for the photos from the 2006
event used in this 2007 video footage.
1976 Pro Street Chevy Vega
Pro street vega I'm building: 14 point cage, narrowed ford 9 inch rear
end, sbc 350 with comp cams Big Mutha Thumpr cam, noisy gear drive, etc etc
1941 WILLYS GASSER ---FRESH BUILD
1941 Willys gasser coupe. Just finished the build yesterday and took it on
its maiden voyage today. Have to be gentle at first and work out the bugs,
then after we break it in we can drop the hammer on it. Car was completely
built at Fast Times Rods in New York with custom chassis, ladder bars, roll
bar, straight axle etc. Motor is a 383 stroker with Canfield aluminum
heads, well built 700r4 transmission from Bobek's Transmissions and Dennys
Nitrous Ready driveshaft.