Supermoto Police Chase
The cop was lit up with sirens on the way to an emergency. The rider with
his music blasting, unaware pulled out in front of the cop rippin down the
Snake. The cop was just a short distance behind the rider so everyone
thought it was a police chase. Even funnier, the rider pulled over to come
up for a second run and the cop continued on. Everyone thought the rider
hid as the cop passed. When the rider came back he had no idea what was
70ton dumper stuck in mud pulled by D10 dozer
This CAT777 dumper got stuck in a soft muddy spot and it took a D10 dozer
as well as a big loader to get it out.
We loaded this dumper with single wheels at the rear because owner was
waiting for new tyres to be delivered.
To get to the offloading point we have to cross under a bridge which is too
low for us to pass under. We then offload before the bridge and the dumper
drives under the bridge by its own where we load it again further to
After passing under the bridge we got stuck in a soft muddy spot. Probably
would not have; if we had duals on the rear of the dumper.
Dumper is working on Coal mine in South Africa near Johannesburg.
Dodge Challenger Slow motion Wheelie
1974 Dodge Challenger Slomo Wheelie vid. Santa Pod 2010 eurofinals. By
Blackett Photography. Here the car is powered by a 572ci Wedge motor. Runs
mid 9's @ full weight (3850lb +). To make the caltracks work you need
plenty of front end lift, bump stops were removed and frames notched to get
almost 6 1/2 inches of travel. Something Chrysler never designed that
suspension for I'd guess. We've since improved the bump steer by replacing
parts and resetting the camber / castor as the front has aftermarket parts
and plenty of adjustment.
In reality it's difficut to fully eliminate without going to a strut type
front end, though some people appear to have done it on stock stuff, it
seems to be a common chrysler trait. Check out the superstock video's from
the '70s and most Mopars do it also check out my other real time wheelie
vids you see that the wobble lasts only a fraction of a second.
Thanks for the comments.
Mad Max - Last V8 Interceptor Axle-hop Stop!
Met up with Justice, who runs Maxrockatansky.org and did a little bit of
filming near Lake Lewisville. Thought I'd throw in the axle-hop stop that
you see at the beginning of MM2: The Road Warrior. He doesn't throw it into
reverse, as many erroneously believe. It's this type of stop I demonstrate
1967 Hot Rod Cutlass "Street Bully" 572 Chevy Big Block Burnout
1967 Cutlass "Street Bully" built in California and sold new in Tucson
Arizona. The Olds now has a 572 Chevrolet Rat Roller motor with 620 HP and
650 Ft. Lbs of torque, a 700r4 gear changer with stage 2 kit and fully
manual valve body, the rear end is a 3.90 posi. A Hurst shifter was
installed to give it that Hurst/Olds twist and we added the original Hurst
Olds badges to the car. There never was any Hurst Olds in 1967 and being a
4 door this car really freaks people out. Also there were not many 4 doors
that were hard tops (notice no post between the doors)most were sedans. The
bench seats really take you back to the 60's with the groovy pattern on the
seat material. We added some pearl and candy ghost flames to the super
faded out paint from the Arizona sun and bolted a vintage Cragar SS wheel
and knock off to each corner. Its been a lot of fun and a real BLAST to
drive. Make no mistake, when you hit the start button on the Bully you know
that aint no 330 Olds under the hood. The only problem we seem to have with
this project is keeping rear tires on it ! Thanks for looking and happy Hot