k20 swap ej9 =ek20
honda civic ej9 1400cc 90hp swap engine k20a
kamikaze team from belgium!
JRSC ITR Build Up - Chapter 1
This clip shows the progression of my JRSC supercharged B18c-R DC2 Honda
from it's humble beginnings as a turquoise Vti-R to how it look today.
This movie has a bit of a sad ending. Bye bye B18c-R.
Thats ok though, chapter 2 shows the re-power with a JE/Eagle forged B18c
and a bit more Boost + methanol :)
Credit to Adam Plews for the initial build, my part comes later
Music by Pendulum - Planet Orion
**** For all the haters of the rear bumper, this video is actually getting
pretty old now, the holed bumper is long gone, now replaced by a plain 98
Skunk2 How To: What's in Your Bottom End
Follow along as Skunk2 walks you through a complete engine build. It all
starts with understanding what exactly is inside of your engine block.
Watch and learn.
V6 Honda Civic
V6 powered EG Honda Civic built by Arizona Performance Imports using
Hasport engine mounts
Civic B16 Nitrous runs 0-110mph
If you want to watch car in 1/4 mile 13.28 link here:
My second pull I shifted too early because I was focused on the camera that
was moving around. Bottle was close to empty so it had low pressure. Thanks
for watching and enjoy.
Flits Engine Swap Honda Civic d16 to b18
Uploaded again, this time with freeware audio to prevent Youtube from
blocking the video because of copyright issues.
A timelapse video swapping a Honda Civic d16y8 to a b18c4
Before posting replies about the lamb-doors, I suggest that you check my
latest video first ;)
How To Adjust Valves Honda B18C VTEC 4 Cylinder -EricTheCarGuy
Visit me at: http://www.ericthecarguy.com/
Discussion about this video:
B Series Timing Belt Video:
Valve adjustment tool:
Long feeler gauges:
VTEC explanation video: https://www.youtube.com/watch?v=nc800hkqY2M
I think this might just about complete my valve adjustment videos on Honda
engines. There are only a couple more that I can think of that I haven't
covered like the Vigor 5 cylinder engine and the DOHC VTEC found in the NSX
(that will be a fun one trust me) but that's about it. As you can see in
the video this valve adjustment requires a special tool. You don't have to
use the same one that I used in the video but you won't be able to
accomplish this procedure without some sort of special tool. Once again
make sure the engine is cold and it's probably not a bad idea to run back
through them after you go through the first time just to make sure
everything is still in spec, it's strange how one revolution of the crank
shaft can change things. Otherwise good luck.
Music from Apple's Soundtrack program: Bosa Long
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.