Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

dmax bad shift

this is my truck i just put a new built tranny in. done by myself and probably wrong. the problem shift is at the 6/7 second mark. also at the very last shift i let off so you cant hear it as strong but its there. UPDATE: when i pulled the trans the gapping between the c2s and c3 was wrong and wasnt dissengaging! theres a plastic spacer thing in there was totally shot. holding up nicely now. Dyno'de truck 10-1-11 518.8HP on eddy Dyno.


 


More Videos...


CRANKWALKED? 7-bolt teardown 1080HD
Now this is a story all about how My bearings got flipped-turned upside down And I'd like to take a minute just sit right there And tell you how I used to mix and burn my gas and my air. In RVA suburbs born and raised On the dragstrip is where I spent most of my days Chillin out, maxin, relaxing all cool, 'n all shooting some BS outside with my tools When a couple of guys who were up to no good Started running races in my neighborhood I heard one little knock and my rods got scared And said "You put it in the garage until you figure out where..." I Begged and pleaded that it not be that way, But it didn't want to start and run another day. I kissed it goodbye, because the motor punched its ticket I got out my camera, said "I might as well kick it." Crankwalk yo this is bad Drinking metal shavings from an oil pan. Is this what the rumor of crankwalk is like? Hmm this won't be alright But wait I heard knocking, grinding and all that Is this the type of failure that should happen to this cool cat? I don't think so, I'll see when I get there I hope they're prepared for this video I share. Well I pulled all the bolts and when I came out There were chunks in my fluids in the pan and they drained out I aint all depressed cause I seen this before. I got my books and my wrench and we'll do it once more. I sprang into action like lightning disassembled I whistled while I worked and my hands never trembled If anything you could say that this bling is rare, and when I saw what broke I stained my underwear. I turned off the air compressor 'bout 7 or 8 And I yelled to crankcase "Yo holmes, smell ya later" I looked at my internals they were finally there To sit on my workbench and stink up the air. Audio track by RojoDelChocolate. Here's the 48,000 mile-old 7-bolt I blew up summer 2011 after over 150 drag passes, a half dozen Dyno sessions, 4 transmissions, 3 clutches and 10 years of hard all-weather use.





Rental Car Olympics





Joshies Towing Service
Been working on my grandparents property, part of the estate, and this trailer just had to go! So I used my 2002 Duramax to pull it out, and I am willing to say even though i massivley overloaded the truck with the 50 foot trailer, i am damn impressed!





Duramax Loaded Going Up Steep Incline
Who would have thought that these hay bales could be so heavy. My dad insists that his duramax out performs my old 24V 5.9 cummins when it comes to pulling power.





How to Fix the Weak Link in an Allison Transmission
http://www.4wheelparts.com/parts/bd-diesel/turbochargers.aspx - BD Power has discovered that the 5th gear is generally the weak link in an Allison transmission. But thanks to what they've dubbed the "crazy washer," you can get 50% more clutch material and handle 500 more hp. Find great BD Diesel products for your pickup truck at www.4WheelParts.com.





you know your stuck when. . .
f250 diesel stuck in vermonts northeast kingdom





2002 Duramax LB7 Hazing and driving after new injectors How it sounds and Pulls PPE 2 tune
Showing what bad hazing looks like and what my Duramax sounds like with light load and WOT Even with the Bad injectors the truck had great balance rates and mpg.





Duramax Engine Assembly with Jason Aldean "She's Country"





Duramax Disaster
Burnout contest at the 4wheel Jamboree 2012 in Lima, Ohio on May 20th. This truck blows it's turbo, and apparently caught on fire mid way through his run. (even though I never saw any flames) Fortunately for him, he won 1st place in the end.





Allison Transmission - LCT 1000 - Teardown Inspecton
Teardown Inspection and Preparation For Shift-kit Installation. Here we see an Allison LCT 1000 teardown inspection and you can also see how this transmission is being used on some heavy duty trucks. Very tough and durable. On part 2 of this video, we're installing a Transgo shift kit to make this unit more heavy duty than it already is. So watch part 2 of this video as well.





2003 Powerstroke pulling out 2010 Duramax
2003 Powerstroke Diesel pulling a 2010 Duramax Diesel out of the water/mudd, dont ask why he drove out there but we drove up on him while heading out to a fishing hole, guess the dealer told him it would float when he bought it.....





D8 Front Idler Install
This is how we installed a front idler.





Diamond Eye 5" Straight pipe installation on a 2006 Duramax!
Down Pipe back full Exhaust how too





Duramax's hole shot
A set of Duramax's hole shots. Both trucks are 600+ hp. Both have built trans from Merchant Automotive. Red truck is Fuel heavy. Tan truck is fuel hungry. Both 4x4. Red truck is lifted 6in and 35s. Both have tie rod sleeves, and ladder bars.





Push Start DW20 Scraper
This traptor hasn't been started in a long time.




Which car is faster? Which Car is Faster?





Similar 1/4 mile timeslips to browse:

1957 Austin-Healey Sprite : 8.780 @ 155.000
darren veal, Engine: 466 bbc, Supercharger: no Turbos: no


1958 Austin-Healey Sprite BUG EYE: 9.110 @ 148.230
DARREN VEAL, Engine: BBC 454, Supercharger: NO Turbos: NO Tires: M/T 28X11.5X15


1993 Toyota MR2 GTS: 10.050 @ 138.000
Michael Lantigua, Engine: 5s, Turbos: PRESICION


1982 Datsun 280 ZX : 10.256 @ 124.300
Grant, Engine: 2.8L, Supercharger: n Turbos: n


1993 Toyota MR2 Turbo: 10.910 @ 127.570
Ray Bridenstine, Engine: 2.0 Liter, Turbos: Greddy T78 Tires: et street


1991 Toyota MR2 Coupe: 10.943 @ 129.800
Jeff Fazio, Engine: 3SGTE 2.149, Turbos: GT35R Tires: BFG Drag Radials


1994 Toyota MR2 : 11.030 @ 115.000
Thomas Clark, Engine: 2.0, Turbos: turbonetics ballbearing Tires: NITTO NT555R 335/3519 NITTO NT555ZR 255/4019


1992 Toyota MR2 Turbo: 11.038 @ 125.950
Jeffrey Burke, Engine: 2.0 liter 3SGTE, Turbos: Garrett GT35-R Tires: Mickey Thompson 10x15x26 Drag slicks


1976 Datsun 280 ZX : 11.151 @ 111.670
Ed Gawrych, Engine: 355 SBC, Supercharger: - Turbos: - Tires: BFG 26.5-8 Drag Slicks


1991 Toyota MR2 Turbo: 11.185 @ 125.620
Kris Osheim, Engine: 2.2L 3sgte Gen 3 stroker, Turbos: Street Brawler GT35R Tires: BFG Drag Radials 235/60-15


1991 Toyota MR2 SW20: 11.280 @ 125.500
Kazu Ikeda, Engine: 3S-GTE Gen.II (JDM), Turbos: CT-26 Hybrid, 60trim Tires: F=175/65/14 R=26/8.5/14 M/TSlicks


1975 Datsun 280 ZX 280Z: 11.523 @ 127.410
EJV, Engine: 6.8L stroked LS3 V-8, Supercharger: n/a Turbos: n/a Tires: 195/75-14 fr, 235/60R-15 MT ET Streets rr


1986 Toyota MR2 AW11: 11.596 @ 118.096
Hector Rodriguez, Engine: 4agze, Turbos: Garrett T3 .63 a/r stage 3 Turbine, T4 .60 a/r 57 trim Compressor Tires: Nitto NT555R 20555/14


1991 Toyota MR2 GTS Turbo: 11.700 @ 0.000
Juan B. Pena, Engine: Gen 3 3SGTE, Supercharger: NON Turbos: GT30R Tires: Front 215/45/17 rear 225/45/17


1990 Toyota MR2 SW20: 11.768 @ 122.380
Jason Walker, Engine: 3SGTE, Turbos: TO4e custom wheels Tires: falken azenis RT215 - street tyres


1992 Toyota MR2 Turbo: 12.250 @ 120.190
Enrique Aguilera, Engine: 3sgte, Turbos: Garret GT3071 Tires: 17


1992 Toyota MR2 Turbo: 12.463 @ 110.030
Adam Crews, Engine: 1994 Gen3 JDM 3SGTE, Turbos: GT28RS Tires: 255/35/18 Falken GR Beta FK 451


1985 Toyota MR2 MK1: 12.500 @ 122.900
Thags.Govender, Engine: 1600 4AGZE, Turbos: TURBONETICS T3/4BSTGV 60-1


1991 Toyota MR2 Turbo: 12.511 @ 99.910
Cliff Taylor, Engine: 2.0, Supercharger: none Turbos: CT-26 Tires: Slicks


1986 Toyota MR2 AW11: 12.584 @ 110.850
Héctor Rodríguez, Engine: 4AGTE, Turbos: T3 .48 a/r stage 3 Turbine / T4 .60 a/r 57 trim Compressor Tires: Nitto NT555R 205/55/14


 


©2014 DragTimes - Disclaimer