2010 Camaro SS STS Twin Turbo Install - On Lift - Walk Around

2010 Camaro SS STS Twin turbo build... walk under build progress, pipe plumbing shot. LS3

More Videos...


How to install a turbocharger.
This video provides key guidelines and outlines critical steps to follow when replacing a Garrett turbocharger.





UPP's G8 Twin Turbo Install Instructions
Installation instructions for our new Pontiac G8 Twin turbo Kit.





1500 hp Camaro Running on the Street!
Film created by NelsonRacingEngines http://www.youtube.com/user/nelsonracingengines Website: http://www.nelsonracingengines.com/ This is a fabulous Super Car Beast. This video gives the viewer a good look into what it takes to build a Nelson Super Car. This 2010 Camaro is torn down to the ground and then rebuilt. Cheap it's not. This film has many street sequences from various camera angles. We hope you enjoy this film. More information can be be found at http://nelsonracingengines.com and http://nelsonsupercars.com. For help with your video production go to http://VeritasMovieStudio.com. To see the full Dyno test of the engine in this car go to http://www.youtube.com/watch?v=NZDfNSIIedw&feature=plcp . Video @ Licensed CC 3.0 for Commercial use Visit NelsonRacingEngines for more Website: http://www.nelsonracingengines.com/





"350Z STS Turbo Installation Checkup" by Nutnfancy
More unprecedented shop talk with Rick Squires from Squires turbo Systems as we check in with the 350Z build. It took a bit longer than expected but as you'll see the ECM flash was complicated by this version being unsupported by the "UpRev" brand tuning software. Once the card was updated, they could crack into it for tuning. Alarmingly, the Nismo Cold Air Intake I had put on allowed dirt into the manifold. It came throught the hydrolock flapper valves on the tubing...a horrible design (so much for quality stock Nissan parts I guess). Engine damage if any is undetermined at this point. We show and discuss the oil, fuel mods and show the underbody ducting and installation of the STS rear mount turbo. I make up a funny word along the way, "densify" and talk about the specific goals, durability, and rwhp of the build and how I like the 350Z's underdog nature. To run with a Z06 this car will have to push the 1/4 in 11.7 secs, trapping at 124 mph (Road and Track official Corvette Z06 test data w xlnt driver, sea level). That might be a tall order but I'm hopeful and this car's allow about that challenge. TacticalDoodle, Rick, and I share some laughs as the technical talk progresses. If you're considering forced induction, this another vid worth your time.




Follow