Russian Rotary Vane Engine
Rotary Vane Engine proposed to power Russian hybrid car 'ё мобиль'
Evinrude 300XP -91
After a few hours in the workshop..
The expansion chambers are "home made" by hydroforming. The original Exhaust is milled away and the engine
block is filled whit plastic.
This engine will get electronic fuel injection and will not be used in a
Note: This is a sponsored video for Forge Apollo
The Mazda Rotary Engine Part 1
Educational film by Toyo Kogyo about the Mazda Rotary Engine. Shows how the
Rotary engine works with comparisons to the Piston Engine. Also shows the
Mazda RX500 test vehicle on a banked circuit and the Mazda Cosmo Sport (or
110S). Originates from the late 60's.
CRANKWALKED? 7-bolt teardown 1080HD
Now this is a story all about how
My bearings got flipped-turned upside down
And I'd like to take a minute just sit right there
And tell you how I used to mix and burn my gas and my air.
In RVA suburbs born and raised
On the dragstrip is where I spent most of my days
Chillin out, maxin, relaxing all cool,
'n all shooting some BS outside with my tools
When a couple of guys who were up to no good
Started running races in my neighborhood
I heard one little knock and my rods got scared
And said "You put it in the garage until you figure out where..."
I Begged and pleaded that it not be that way,
But it didn't want to start and run another day.
I kissed it goodbye, because the motor punched its ticket
I got out my camera, said "I might as well kick it."
Crankwalk yo this is bad
Drinking metal shavings from an oil pan.
Is this what the rumor of crankwalk is like?
Hmm this won't be alright
But wait I heard knocking, grinding and all that
Is this the type of failure that should happen to this cool cat?
I don't think so, I'll see when I get there
I hope they're prepared for this video I share.
Well I pulled all the bolts and when I came out
There were chunks in my fluids in the pan and they drained out
I aint all depressed cause I seen this before.
I got my books and my wrench and we'll do it once more.
I sprang into action like lightning disassembled
I whistled while I worked and my hands never trembled
If anything you could say that this bling is rare,
and when I saw what broke I stained my underwear.
I turned off the air compressor 'bout 7 or 8
And I yelled to crankcase "Yo holmes, smell ya later"
I looked at my internals they were finally there
To sit on my workbench and stink up the air.
Audio track by RojoDelChocolate.
Here's the 48,000 mile-old 7-bolt I blew up summer 2011 after over 150 drag
passes, a half dozen Dyno sessions, 4 transmissions,
3 clutches and 10 years of hard all-weather use.