'79 Ford with 460 Big Block
Knox County Career Center Project, 79 ford with big block 460 bored .60
over, 35" buckshots, fully restored, scarlet & gray paint, tailgate signed
by Jim Tressel & Archie Griffin, headers, glass packs.
This truck came out of the paint booth and was assembled all in the same
morning it was auctioned by collaboration effort of two vocational programs
and many teachers.
Follow Fsca72 on Facebook http://www.facebook.com/fsca72
Chevy Impala 572 Big Block 750HP!!
Cruisin' in the bad ass Chevy Impala. By www.nelsonracingengines.com
- 572 Big Block Hot Rod series (9,4L)
- 750 HP @ 6000rpm
- Runs on pump gas.
- Richmond 6 speed manual with dual disk clutch and a long shifter.
- 12 bolt 3.55 geared rear end.
- Hotchics suspension.
- Bear 4 wheel disk brakes.
- Custom 2.25 primary pipe on header with dual 3.5 inch Exhaust and dual 3.5 inch 2 chamber Flowmaster
- Engine is carbed with a 1050 street dominator with progressive linkage
and uses MSD ignition.
If you have a nissan skyline or other rice crap, start crying!
Twin Turbo Big Block Ford Hemi Dyno - 2400Hp
Developed, machined, built and tested at M2 Race Systems. Twin turbo big block Ford Hemi, 540CI, 2400Hp@22psi
(2000+ ft*lb of torque!), running on methanol. The smoke you see at the end
of the pull is steam coming from the water brake.
Chevy 20" Lift 49" Tires with Big Block 454
For everyone's information; its just a random small "mud pit" out in the
middle of the hills, with zero rivers or lakes anywhere close to it.
CHECK OUT MORE AT:
twitter : https://twitter.com/GrahamChaster
facebook : https://www.facebook.com/iwideopen
tumblr : http://betterthanbroke.tumblr.com
instagram : http://instagram.com/betterthanbroke
instagram : http://instagram.com/chaasta
MY YOUTUBE CHANNELS:
1993 Big Block Ford Mustang, Big Cam !!!! *Turn up your volume so you can hear it!!!*
TURN UP VOLUME! SO YOU CAN HEAR THIS!!!
Update(Oct. 7, 2012) Well Pulled Heads off a few months ago and found out
exactly what was wrong, passenger side head has hole inside #4 Exhaust Port, Got the Other heads to machine
shop, just trying to save up the money necessary to pick them up, should
have them back by December, hoping to have back together by Late January of
2013 or early Feb.!!!!!! Stay Tuned, Subscribe and stay in touch, hopefully
with some luck and lots of money, will have a new video on here by Spring
of 2013, fingers crossed.........
Update(Dec. 4, 2011): Well I have more bad news, got bad set of heads, so I
have gotten another set of used ones, they are stock 1968 heads, got to
raise the money to get the BIG valves installed in these heads, Stay Tuned,
Subscribe and stay in touch, hopefully with some luck and lots of money,
will have a new video on here by Spring of 2012, fingers crossed.........
Thanks to all that liked this, well for now, she blew head gasket,
hopefully I will be putting a new video on before end of summer of a
burnout or something, got to drive it once and she is a hand full !!!!
Ok i was bored and finally figured out what I could do to video my car with
my Pile of JUNK Kodak camera. ENJOY!
Please no comment about me just the car, thanks!