406 hp 400 ft lbs.bedroom built, chevy engine dyno
Built this in my bedroom a few winters back and its sweet. 406 horsepower and 400 ftlbs of torque. The first pull is to 6200 rpm and the second is to 6500. lunati roller cam, weiand stealth intake, holley aluminum heads, eagle rotatiing assembly, 4 bolt block .030 over
406 s10 vs. 422 vette
My dad in the blazer w/ a new 406 against his buddy in the vette with a 422 stroker.
1982 Chevy S-10 406 SBC
Gettin the drag truck ready for the 2010 drag racing season. By the way the line lock still works haha
Chevy S10 5.3 ls1 turbo dyno 445whp run 3
11/28/09 psi proformance Dynojet run 3 445whp
Chevy s10, stock 5.3 ls1 truck block, zo6 cam, zo6 valve springs, megasquirt ms1, msd 6010 ignition controller, turbo350 trans, ford 9in rear, 29"in tall tire, 13psi on pump tuned by kptuning
1986 Chevy Truck 1/2 ton, 4x4, 406 sbi, dual exhaust
1986 Chevy 3/4 ton truck 4x4. 400 sbi bored out to 406, edelbrock quadra jet carb, edelbrock aluminum intake, headers, dual straight pipes, lifted on 35 inch swampers.
67 camaro 406 small block chevy-LAUNCH DOWN THE DRIVEWAY!
Sorry it came late I was a bit busy through out last week so, this is my dad launching his car down the driveway and letting it idle on the driveway. Hope you enjoy the vid, please comment, rate, and subscribe:)
Chevy 406 idle clip
406, 5.7 rods, vortec bowtie large port 215cc heads, 66cc chambers, forged flat tops, 11 to 1 comp., isky solid roller, 272@.050 with .505 lift, corrected to .539 with 1.6 roller rockers, pro products hurricane intake, holley 750 double pumper, super comp 1 3/4 headers, full 3 inch Exhaust with h-pipe and flowmasters. Currently has run a best of 7.17 @ 96mph 1/8 mile on 93 pump gas. Best standing 1/4 of 11.40 @ 118mph.
