When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $760.00
These headlights will take approx 4-5 weeks to produce. Please be aware before purchasing. This is the ultimate OEM look with a modern appearance!
Contact me directly if you wish 3000GTStealthGTO at gmail to see how you can get reduced shipping.
CLICK HERE TO SEE ALL MY 3000GT AND STEALTH HEADLIGHTS AND TAIL LIGHTS FOR SALEYou are bidding on a complete set of Mitsubishi 3000GT or Dodge Stealth glass headlights with repainted jet black OEM inserts and halos. The halos are freshly installed with zero hours on them and rated at 50,000 hours. CLICK HERE TO SEE BEFORE AND AFTER VIDEOThe following is included in the service you are bidding on.* Bake off the glass lens
* Remove all old OEM glue (20 years old)
* Clean out the headlight bucket
* Remove the color/black insert
* Remove the glass projectors and clean them to remove finger prints and dust
* Sand blast and paint all mounting hardware
* Lay 2-3 coats of flat black paint to hardware
* Seal the mounting hardware so the paint is less likely to chip of fade
* Wire brush the tops of the screws for mounting hardware and give light coat of black paint
* Install halos (very bright LED with shroud as shown and I provide them in the fee for this service)
* Mount halos on the rings with high quality clear epoxy
* Shrink heat wrap wires for halos in black so they are not noticeable.
* Remove the old \"L\" rubber parts from rear of bucket and replace with new rubber.
* Run Halo wires through bucket
* Solder 2-3 feet extension for positive and negative for each halo.
* Shrink heat connects
* Place new OEM quality glass seal.
* Thoroughly clean the inside and exterior glass.
* Place glass back on headlight bucket and seal.